【BABYFACE】Axle Protector Review
good-looking
OEM is expensive, so we chose here.
I have not yet fallen over, so I do not know how effective it is.
I think it looks good.
Responses
Other reviews
Maybe I don't need Front.
I put it on a 2022 XSR900.
Some say it is better not to put it on because it may slip and aggravate the situation, but I assume it will fall over at low speeds.
I thought that the Protector has little protrusion, and since it has a Radiator, I think it is not so meaningful even if it is attached, since it is originally wide.
I hope you don't experience any effects.
Deep socket 10mm is Quantity:2pc. Set is required, so please be prepared.
View detail
Easy detachment!
Rather than a rear slider, the Axle Shaft was installed to make it easier to attach and detach the Axle Shaft.
It can be used as a handle like Doorknob when pulling out shafts, and when inserting shafts, the triangular pyramid shape makes it easy to insert the color, etc. without resistance.
Of course, it would also serve as a Slider, but currently it is benefiting from the detachment process.
View detail
Axle Slider
These are custom parts that only look good.
We have the same Babyface as Frame Slider.
View detail
It was not long enough and could not be installed.
Installation is easy and anyone should be able to install it easily.
The one I purchased this time could not be installed due to insufficient length.
View detail
Simple is good.
I used to use Axle Cup, but I decided to use Slider because it is a "Chain". It is smaller than I expected, but it looks OEM.
I think it is also the strongest in terms of cosmetics.
View detail