【J Trip】Long Roller Rear Stand (Body Only) Review
It goes up very lightly.
We are z900RS.
I had wanted a maintenance stand for a long time, but I also thought that a center stand would be fine, but I wanted to install a YOSHIMURAHand Bent, so I gave up on the center stand and decided on the maintenance stand.
Impressively, I was surprised at how lightly it went up.
Probably light enough to be raised by a Small school age girl. I was surprised.
As I have written elsewhere for those who use YOSHIMURA, please use a bracket with the opposite shape of a normal bracket for the old-fashioned YOSHIMURAHand Bent, since a normal bracket will scratch it.
What is the opposite of normal, on the Maintenance Stand side, [Ts] You can install a Bracket like the one shown below, but you can also use the Material:Plastic round shape circular fixtures.
[Ts] Brackets like the one shown below are brackets that can be attached to the body of the vehicle.
I have always wondered if there might be a reason why only YOSHIMURAHand Bent's Exhaust System is parallel to the ground.
It's still different, isn't it? It's originally for re−sing!
Responses
Other reviews
Jay TripMaintenance Stand
I was worried about the cheap Chinese ones from Amazon, but I decided to buy the Jay Trip one for its long and safe use. I have not used it yet, but it is well made and the purchase was a good decision. View detail
Great stability!
Anyway, easy installation. Lever length is just right.
A 200 kg Large Motorcycle can also be easily carried.
Four-wheel Tire and sturdy Chassis for great stability.
View detail
Definite shopping
Stable J-TRIP.
Used in conjunction with V receiver 1.
Impeccable.
View detail
Slightly disappointed.
[How is it used?
Used in YZF-R6 (2019) with V-receiver.
I am new to buying Rear stand but have rented a Short from J-TRIP.
Was the one you received as per Image?
It was heavier than I expected, but not a problem at all.
The large size was as shown in the image, but it is still large compared to the short size.
How was your experience with it?
It is easy to raise and lower, and although I was worried about the short version, I made the right choice by choosing the long version.
However, even with Short, Stand for Beginner was easy and did not require much strength.
The screw holes are too large or the bracket is wobbly even when the bolt is tightened firmly.
[Points to note]
In the case of the V receiver, even at the lowest setting, it floats about 4 cm, so a little force is required to raise it.
If you want to raise it with light force, it is better to choose Stand for Beginner because Stand for Beginner will be in a lower position.
View detail
J-TRIPSTAND
I purchased this product for ZX-25R maintenance.
I was confused between Short and Long Type,
I am happy with Long Type.
With Long, it is quite easy to lift with little effort.
Recommended
View detail