【ENDURANCE】Fender Eliminator Kit Review

Refreshing and Style!

We chose this product because we wanted to refresh the Blinker from an OEM Fender. I considered other manufacturers, but I thought that this product, which uses OEM parts, would be easy to obtain even if the Blinker was damaged due to a fall, etc. I also thought that a product with an LED Lamp would also be a good choice if the Lamp ran out. Also, the product with LED Lamp was also chosen because we thought that if the Lamp ran out ….
I was assured that the product was thick and sturdy.
Installation is no problem as long as you follow the instruction manual without rushing. View detail

Can be attached to JC92 2023 MODEL.

Installation Instruction Manual can be downloaded from our website, it is not attached for environmental protection.
With a cold drink in hand, even a novice like me could install it in about 40 minutes.

The quality is a trusted Endurables product, so there are no holes in the mounting position, no machining, no bali etc.
It is a little bit of a little bit.

Since Wiring will be partially exposed, flooding treatment is required by each party. View detail

Endurance Fender Eliminator Kit installed

Fender Eliminator Kit for JC92 has few options.
I have twice purchased from We BigSite, specifying the make and model of the car, but I couldn't install it either time.
Site's search system is unreliable.
Back to the story since it was Gap.
I felt that this Kit was inexpensive and quite thoughtfully designed.
I was relieved to be able to install Snap around the Mounting Bolt area with a collar.
I think Reflector is good for quick installation of OEM products.
However, installing a reflector that is originally quite large in size does not look good.
The height of the blinker attachment area appears to be too generous and elongated.
I think it should look a little shorter.
Either way, I recommend this Kit because of its price/effectiveness and affordable Gold amount. View detail

PENALTY!

The design is simple and the installation was very easy. The material is steel, so it is not lightweight, but considering the price, it is a very well made product. View detail

You can install it by yourself as usual.

When I installed it by myself, the most troublesome thing was to remove the Blinker from OEMFender, but it was so hard that it was troublesome.
The impression after the installation is that the Rear Fender that was sticking out to the rear is now small and tightened up.
However, because the material is steel, I think that the back side which the Small stone hits should put up Cutting sheet etc. beforehand, and the one which works from it, it will not be troubled with the measure of Rust etc. afterwards. I put up the seat of Carbon Style.
The installation time is about 1 hour if you do it in hot weather. View detail