【Magical Racing】Universal Seat End Review

Cosmo!

It will SUPPORT your hips.
It's easy to get the Cornering posture and
It also assists with Knee grip.
I am glad I installed it! View detail

Used for Seat Cowl for Race

I purchased the 20? I am using it with the same Manufacturer 10? that I had in stock, making a total of 30? View detail

On the butt Hold.

[How is it used?
Used on a YZF-R25 with Saitaniya's Full Cowl for Race.

Was the one you received as per Image?
It was exactly as shown in the Image. I was torn between 20mm and 10mm thickness, but 10mm was the right choice!
Also, since the elasticity of Sponge is quite high, processing with Cutter may be a little difficult.
Roughly cut with Scissors, and then trim the corners with File for a clean finish.


Was the installation difficult?
It's that simple. Simply degrease the surface to which it is to be affixed and stick it on.

How was your experience with it?
With my body, YZF-R25 is a little tight, and my buttocks hit the Seat Cowl when I get down in Straight, etc....
If it is not attached, there is still no sense of Hold and it gives Damage to Cowl.
Therefore, by installing Seat end, this problem was solved.


[Included Parts:were they on?
Nothing.

[Was there anything that disappointed you?
None in particular. The adhesive is very strong, so once it sticks, you should assume that it is impossible to fix.
Make a pattern on a cardboard or print paper, and cut the paper accordingly.
You can also use masking tape or similar to mark the surface in six places before attaching.
I think there will be few failures. Please note that if you try to forcibly peel off the paint, it will take away the entire coating. View detail

It would be nice to have it

the cowl is Saitaniya Cut the shame because it was too large The thickness is 20mm, but I think 10mm is good enough I think 10mm is a good enough thickness
The feel of my buttocks felt more Hold after using them I'm going to try the 10mm next time
The price is cheap, so it's good to try VANVAN with Double-sided I think that it can be substituted for Spacer because it is a tape machine View detail

OEM Replacement

The OEM stuff is torn up due to deterioration! I thought about playing it, but I changed it to this type that grips firmly
It's a simple job to install it with the attached double-sided tape A strong Double-sided because the edges were floating due to a little rounding I changed to Tape and stuck it on
It looks better than a tattered stone and has a neat, race ish feel to it
I actually installed it just for the look and feel of the car, but it's solid on the Circuit It's more effective than I thought it would be with the stuff that grips my buttocks
The thickness of the Grip is perfect and it doesn't get in the way and is useful when you need it
How is the durability because the material is hard Sponge? However, it is inexpensive, so when it is worn out, I think it is enough to renew it with a new one View detail