【Ladybird】Mechanical Brake Switch Review

Brake switch on Radipon

My hydraulic switch went bad and I was looking for a Mechanical switch and this is the one I got.
Installation was easy with the Instruction Manual.
I like it very much View detail

MechanicalSwitch is built to not malfunction.

My previous Brake from another company broke, so I bought this product which seems to be well made in terms of safety.
It is a comparison with a certain factory-made Switch that was used before.
The 0 factory model comes with a stainless steel brake pivot pin, and the switch itself is a compact brembo.
I liked the Large variant because of its simple and stylish construction that does not destroy the design of the M3Bolt, but the M3Bolt one to BrakePivot!
So, if you run repeatedly, the switch will turn and the brake will stay on.
It happened many times, I over tightened the M3Bolt and distorted and broke the Brake switch and the Plate that holds it.
It was then physically and rationally installed and has been in use for about 6 years.

The newly purchased Switch made by Lady Bird is made to be conspicuous by the thickness and the size of the Switch which is Large, but
There is a stopper that prevents the Switch from malfunctioning, and it is well made, so I was able to install it with peace of mind.
However, it is not possible to install it only with the attached Hex wrench. Separately, 5.5mm Spanner, Wiring, Electric Works Pliers, etc. are necessary.
If you have never made a Wiring before, it may be difficult to install.
Also, since the brake switch is thick, it may interfere with the brake hose depending on the hose routing and may not be able to be installed.
I like the rugged design, but the brake switch is a prominent design, so tastes may vary. View detail

Reverse actuation

I installed it on Ninja250 Radial master (brembo).
I installed it as per the Instruction Manual and tested the lighting.
When the brake lever is not held (SwitchON, pressed) Lights.
With the brake lever held (Switch OFF, not pressed) "Turn off"
and lights up in reverse of normal operation.
Just to be sure, I tried it with the OEM Brake switch and it works fine, normal operation (SwitchON = off, SwitchOFF = on).
Because it is not possible to run in the city as it is, the brake switch of OEM is processed in time, only the base plate of the commodity concerned is diverted, it installs, and it operates...
PartsParts itself was beautifully made, and "Less malfunctions, more reliable Switch. and the product description, but it is in a state of dissatisfaction. View detail

One of the Best Mechanical Switches Out

There's only a couple of mechanical switches out for the non-RCS Brembo radial master cylinders and this one checks all the boxes: 1. Looks good ☒ 2. Works well ☒ 3. Affordable ☒ Installation is pretty straight forward, hardest part was the trial-and-error related to which wire goes to the switch to work with the OEM harness. I would recommend this switch to anyone looking for a proper mechanical switch. View detail