【amon】Rectifier Diode (1A) Review
Expected
I was concerned about the dim glow of the post-attached (added) Indicator, so I decided to add a rectification Diode.
When I replaced the meter with a Universal one this summer, there was only one warning lamp, so I purchased an LED lamp from KIJIMA and added an Indicator Lamp, but the Red Lamp was glowing dimly. Well, if I didn't care about it, it would have been fine, so I didn't touch it until now, but recently, I decided to add a rectifying diode while reviewing the wiring.
After following the instructions and incorporating it into Wiring, I was able to eliminate the blurriness of the Lamp, but Wiring became so long that it was difficult to store it.
Responses
Other reviews
A must have Hazard addition to your Handlebar Switch.
I bought this to put the NC700X OEMHandlebar Switch on my Grom JC92.
By using the NC700's Handlebar Switch, the Hazard and Passing functions can be added.
I used the teachings of our predecessors that you have published on the Net as a reference for my Wiring.
Thank you, my predecessors.
The purpose is to prevent backflow into the Hazard circuit when the Blinker is activated.
Quantity:Pair (for Left and Right) Quantity to bite, BlinkerWiring:2pc. Set is required, so Quantity:1 Set of 2pcs.Pack will be very helpful.
The wire is connected by soldering, and the connection part is protected by the expansion tube.
The Diode itself comes with a Protective Tube from the start.
A SORD and Ka SORD are very easy to recognize by the color of Wiring. (It is one way from White to Ash)
Thanks to you, we were able to add the Hazard function to Smooth.
Very satisfied
View detail
For Blinker processing
Purchased to install Hazard
You can buy a Diode and assemble it by yourself, but it's a hassle to put a solder on it It would be helpful to have such a product
I don't have a Blinker LED, but even if I did, I would be able to help you Parts
View detail
Along with LEDization
I changed it to LED Blinker, but thank you very much for Quantity : Pair (for Left and Right) I turned on at the same time ... Why did you investigate and found out that Wiring to BlinkerIndicator was the cause, and we dealt with this product.
Blinker's Quantity : Pair (for Left and Right) Attach this to the + line of, and - to make it to Earth to make Wiring new.
It began to blink and flicker without any problems.
Because the content is just a clean flow Diode, those who are easy to purchase electronic parts do not purposely pursue this measure cheaply even if you do not buy this item.
View detail
BlinkerIndicator
BlinkerIndicator has Single Motorcycle
It is a necessary part to make Blinker bulb a LED
I made it to Blinker relay for LED
Those who are funny to blink may be due to not attaching this
View detail
Honda It used for High-beam-indicator creation of a MONKEY. Does it use, also when making a Hazard? operation is perfect -- it is . However, although it is a mere Diode, if a little high, I regard this price as ?.
Honda It used for High-beam-indicator creation of a MONKEY.
Does it use, also when making a Hazard?
operation is perfect -- it is .
However, although it is a mere Diode, if a little high, I regard this price as ?.
View detail