【BEET】Taper Bar Handle Review
very good
The Handlebar has a good width, and when the angle is adjusted, it tilts forward, putting the load on the Front, and the Corner ring becomes Smooth.
Responses
Other reviews
Shoulder stiffness is better.
Positioning is easier and more comfortable than OEM. View detail
Width is nice.
Since my height is 165cm and I am small, STD Handlebar has a good height, but it is too wide and tiresome. I am considering to use Handlebar Up Spacer. I put the aluminum par end of Babyface without Weight, but I don't feel vibration at all, so I will ride as it is. View detail
Very good!
Installation was not that difficult.
It's a little lower and shorter than the OEM so it's easier to maneuver around town.
The color is Black, so I feel more relaxed with a sense of unity.
View detail
Universal but dedicated
I think that it is not necessary to describe especially about the installation, so I omit it. Because it is the one that the hole was drilled for Z900RS in the Universal Product, it says that there is no problem, and I confirm it to the manufacturer and continue using it. I think that it is good if I check it occasionally because it is not especially rattling or loosening. View detail
A classic = proof that everyone recommends it.
The OEM Handlebar is wide enough that those with less than a standard build will have to spread their arms to ride it.
My shoulders are stiff.
Recommended Points made by BEET are as follows
? Hole drilling processed
Same Taper Handlebar as OEM
Light in aluminum
Memorywith Gauge makes it easy to use Handlebar's Center, etc.
Demerit
Because of the tapered handlebar, there is a clamp around the handlebar center for attachment, etc.
Difficult to put on.
View detail