【CF POSH】Flat Face Throttle Cone Review
Fits: HONDA ZOOMER(Ruckus), HONDA GORILLA, HONDA APE 50, HONDA APE 100, HONDA Live DIO Series, HONDA MONKEY, HONDA MONKEY, HONDA XR50 MOTARD, HONDA XR100MOTARD
CF POSH Flat Face Throttle Cone
I searched to replace the throttle grip of my genuine Ape 100 Type D, and unfortunately, only CF POSH products were in stock. Because it is an old model, after-parts are in short supply. I went down to the parking lot to replace the throttle grip and replaced the grip. This is a very easy replacement. You only need to loosen one screw bolt. As a user, there is little difference between the genuine product and CF POSH's 15% quick grip. -------------------------------------------------- -------- I searched to replace my genuine 100 type D throttle grip, and unfortunately there was only CF POSH product. It is an old model, so there is a lack of inventory of the after parts. I went down to the parking lot and replaced the grip to replace the throttle grip. Very easy replacement work. Only one screw bolt is solved. The 15%Quick Grip of the genuine product and the CF POSH is inadequate to feel the changed part as a user. Powered by Google Translator
Responses
Other reviews
Very easy and a little high Solo
Used for HA02-180 to square-grained CUB No. 90Custom.
I saw other people's impressions and gave it a try myself.
It is about 5mm shorter than OEM. This is unavoidable since the fitment is MONKEY and APE series and CUB Cas is not included.
The handlebar protrudes 2mm when mounted on the handlebar, but there is enough room for the grip length, so this is not a problem.
Silicon spray was applied to the protruding bar and grips where they might come in contact with each other. So far, no snagging.
Unlike OEM cones, this one is a Pierced Type, which is a good thing.
The product itself is recommended, but there is a possibility that the cone length may not be long enough for other than compatible car models. It is not recommended for safety reasons.
By the way, my CUB No. Grip is for Handlebar diameter Φ22.2, total length 120mm, inner length 118mm.
Quality is a bit cheesier than OEM.
The thickness is slightly thinner, and perhaps because of this, the grips can be inserted and removed without parts cleaner.
This is also not a problem, since Wire is fixed at the end anyway.
Throttle wire play was OK without adjustment, but it was difficult to ride when the operation was severe in town driving, so we increased the play a little, which was originally set to a small amount.
Now SHIFT UP is 15% faster. v
I'd like to see a medium to Large type for Vehicle made.
View detail
Repair Parts
The OEM Product has a non-slip surface that keeps the Grip from coming off, so attaching it to the Bond makes it easier to return the Grip. View detail
With the Grip Exchange
I used them together to replace the Grip.
It is neither possible nor impossible.
View detail
VM26.
I used to have to reset my grip to open it all the way.
It's almost a nice touch.
the last Almost. But it's better than NORMAL.
I don't like the look of High Solo because I don't like the look of High Solo.
View detail
Used for 12VMONKEY
I have to regrip it delicately to be able to open Axel fully.
I feel like I've changed my mind.
I don't want to make it a High Solo in any way.
View detail