【AMBOOT】Ready-to-Hang Bike Cover 2L Review
Fits: SUZUKI KATANA, HONDA VTR1000F, HONDA VT400S, HONDA VT750S, HONDA DN-01, HONDA Integra, HONDA FUSION, HONDA Silver wingGT400, HONDA Silver wingGT600, HONDA CBR 650R, HONDA CBR 1000RR, HONDA CB 650R, HONDA CB 1000R, HONDA CB1300 SUPER FOUR, HONDA NC750X, HONDA NT1100, HONDA VFR800X, HONDA VRX Roadster, HONDA FORESIGHTEX, HONDA 400X,
Ease of use is the best
Can be used immediately after returning from touring.
Easy to install and remove
I was looking for a product that satisfied the above two points and found one that looked just right, so I popped it in.
From the results, I'm really glad I bought it.
It is very easy to put on and take off, the cloth is firm, and I am very satisfied. It is a bit pricey, but if you think you can use it for a long time without Stress, it is rather cheap…?
I bought it when I bought a new Motorcycle, but I wish I had bought it sooner.
Responses
Other reviews
DAYTONAChain beware!
Chain hole is too small to fit Daytona's Chain. View detail
sv650 is 2L
I bought a L because the fit guarantee said L, but when I put it on, it was BitchBitch's tight-fitting.
It took a while but they accepted the return and repurchased the 2L.
Easy to detach and attach.
Rain does not soak through.
It certainly does not dissolve when attached immediately after an Engine stop.
Good
View detail
It was EXACTLY what I expected.
The Motorcycle storage area has a roof, but it is inevitably blown in from the side, so we replaced it with a new one,
The product description indicated that it was not suitable for cars with boxes, so I was prepared to remove the box before applying the cover, but when I tried it, the size was sufficient without feeling too tight.
The fastener is located in the right place, so it is easy to hang the cover and change the large size. When not in use, it can be stored by hanging it on the Hook, so there is no need to worry about it getting dirty from contact with the ground, which also makes it much easier. It may be a trivial matter, but I think I will be able to feel much better if I can save labor on these troublesome things.
The fabric felt a little thin, but on the other hand, I felt it was easy to handle without feeling stiff.
Motorcycle is Z900RS CAFE with SHAD23 side case. Please refer to the following images for reference.
View detail
Does not melt properly
I have not used it that many times yet, but I put it on right after I finish a run and it doesn't melt.
Use is also quite easy thanks to Rear's Fastener.
The price is also on the cheaper side of Body cover, so I am satisfied.
I am concerned that it is a little thin, but …….
Now I'm hoping for durability.
View detail
There is no lie in my name.
How easy it is to write is shown in the product description, and my impression is that I have actually used it. By far the easiest to put on compared to a regular Motorcycle Cover."
It has holes in the front and rear for keys, thick fabric, and heat-resistant fabric on the silencer part.
If we were to seek even greater satisfaction, it would be in the form of improved waterproof performance and a lining that does not damage the vehicle body, but we also like the sense of balance of keeping the price at around 10,000 yen, which is affordable for many users without seeking perfection to that extent.
The disadvantage is that the crosswind enters GunGun from Center because there is no cord to hem only front and back.
If you try to tie the MotorcycleCenter to prevent flapping, this Cover lowers gently from front to back (see the picture in the product description), so the top of the MotorcycleCenter is hollow (good for preventing scratches from rubbing against the tank, but increases the risk of tipping over in windy conditions). (This is good for preventing scratches from rubbing on the tank, but increases the risk of tipping over in windy conditions)
The size of the GSX-S1000GT is a little large if the Pannier is not installed, and a little tight in the back if the Pannier is installed.
View detail