【OPMID】Doctor Lamp Blinker Position Kit Review

I now look forward to driving at night.

Installation was very easy. The instruction manual says to connect the power wire to the 12V output with Ignition ON, but I wanted the unit to work on Small or larger, so I connected the power wire to the + wire of Small.
During the operation check, no matter which of the three types of Controller Indicator settings were made, the indicator would turn red after a short period of time. I was mistaken and found that it was set properly. View detail

Visibility UP!

Installed on VIRAGO250.
The purpose of the installation is to increase visibility at night.
I hope it will make it a little easier to get a sense of distance to oncoming cars waiting for a Right turn, etc.

First, for MONKEY (Universal) The Bullet Terminal with wiring treatment is a thin type, so it is necessary to replace it with a thicker Bullet Terminal for Yamaha cars. Please be careful!

In my case, I had surplus power after changing the headlight to LED, so I wired this product by splitting the +- from the H4 Extension Harness. This way, I can return to NORMAL at any time, and I can use it for other cars as well.
However, because of this, the Blinker position is only activated at Low beam.

When the light is turned on, it does not turn on and off immediately, but rather flutters on and off, giving it a luxurious feel.
The brightness is good at 50% according to the Instruction Manual.
Of course, 100% brightness is more noticeable, but since our Blinker Valve is 21W, we were concerned about Lens melting and power shortage, so we decided on this brightness.
When the beam is set to high, the blinker position disappears, but the blinker is still on, so there is no problem.

I think it is recommendation for those who drive a lot at night. View detail