【DAYTONA】Hyper Sintered Pad Brake Pads Review
Fits: SUZUKI GSX-R600, SUZUKI GSX-R750, SUZUKI Goose 350, SUZUKI Goose 250, SUZUKI Impulse 400 Type S, SUZUKI Impulse 400, SUZUKI Impulse 400, SUZUKI Impulse 400, SUZUKI Inazuma 400, SUZUKI Inazuma 1200, SUZUKI WOLF250, SUZUKI TL1000S, SUZUKI TL1000R, SUZUKI SV650 S, SUZUKI SV650, SUZUKI SV400S, SUZUKI SV400, SUZUKI SV400, SUZUKI SV400 S, SUZUKI RGV250 gamma,
Enough
After cleaning the rear caliper, we found that the pad on the body side was unevenly worn, which led to an unscheduled pad replacement.
Since the cause of the uneven wear was not clear, we decided to see how it would look after checking the installation by rubbing out the piston. I was looking for a cheaper pad than Mega alloy, but one that would work well, and I decided to purchase this one, which seemed to work well at a relatively low price, based on reviews.
After the replacement, I went on a one-day touring trip and drove about 300 km on mountain passes, etc. I had no particular complaints about the effectiveness of the rear brake, and I was able to control the car during cornering, etc. It was not obviously inferior to the Mega alloy. The pad seems to hold up well, so I have high expectations for it as well.
Brake Discs seem to be more aggressive, but I think this area is either for Brake effectiveness or to reduce disc wear. I prefer the effectiveness of the brake disc, so I think that I can replace the disc when it reaches its limit.
This time, since the cause of the uneven wear of the pad was not yet known, we had to choose a pad with a low cost, but we were able to find a pad that demonstrated satisfactory performance, and we believe that we made a good purchase.
Responses
Other reviews
Nice...
I replaced it with a Sintered pad because the Brake squeal would not go away and it was less expensive and seemed more durable.
The pad before replacement came with an unknown manufacturer, so there is no comparison, but it works and does not squeal as usual. 。
Control is much better than I expected, and the effectiveness changes with the amount of force.
It seems to be a bit aggressive to Rotor, which is a concern, but it was a good decision to replace it.
View detail
front pads
Everything was installed well, the quality is good, so far no extraneous sounds, no squeaks, no whistles, no dust, brakes decently, satisfied. I came up, it turns out there are two types of front pads for 100 address, check before purchasing to find out the model year View detail
Kagoshima Touring for 1,600 km
Saganoseki→Aso→Takachiho→Cape Sata→Nichinan and Kyushu Touring 1600 km or so, no problem! View detail
It works well for 15,000 km even with heavy use of Brake!
DAYTONA Hyper Sintered Pads have good initial braking and the first shot is effective even in the freezing cold of midwinter. (excluding Race) 。
I use Hyper Sintered Pads which work well right away in the middle of winter and switch to Golden Pads in the heat of summer.
When I say that HYPERSintered works well at the back, I mean that it does not slip out when you grip it as hard as you can, but it works very firmly! HYPERSintered is a little less effective at the back. On the other hand, the Golden Pad has absolute braking power and works well all the way to the back, but only if it is warmed up.
So for STREET in cold weather, Hyper Sintered Pads were my answer with emphasis on initial braking.
Also, in terms of driving style, I don't do full brake at all. If you use full brake a lot, Golden Pad is better.
HYPERSintered is a threat abrasion resistance, even when Brake well used. (Almost no full Brake) I really recommend it because it lasts for 15,000 km. The Pad thickness is thick from the beginning at 5.5mm and 5mm, which is also a factor in its good holding power.
Brake Pads replacement is life-threatening, so be careful.
View detail
At Caliper's Overhaul.
I replaced the pad at CaliperOverhaul for about half the price. View detail