【ZETA】Titanium Pivot Pin Review

Used for Yamaha Brembo in R7

I couldn't find any information on compatibility, but I used it on my YZF-R7 Radial master.
The diameter and length are the same, so it worked fine.
The weight was 7g compared to the OEM 12g, though not enough to be concerned about.
Wiring is possible due to the hollow structure.

I don't know if there is any change in the feel of the product, but it looks better, so I am satisfied. View detail

For Dress-up

I am happy with the way it looked. The price was cheap and GOOD View detail

Dress-up and Effectiveness Expectations

[How is it used?
Used for brembo RCSMASTER Pivot.

Was the one you received as per Image?
Street Image

Was the installation difficult?
Hexagonal, just tighten with Wrench

How was your experience with it?
Vehicle installation is yet to be done, but I am happy with the look. The standard Pivot is without the umbrella.
Hoping it might help against rain or Dust.

[Included Parts:were they on?
None

[Was there anything that disappointed you?
None View detail

Purchased for Wiring

[How is it used?
I used it for the Master Cylinder of a YZF-R25 in the Race.
The vehicle's MASTER has been converted from STDMASTER to brembo's 14RCS.
WyeRing instruction for LeverPivot section, which was not pointed out in the pre-Race car inspection until now.
To begin with, the RCSSeries is a Master Cylinder for STREET, so the bremboOEMPin is not hollow so that it can be wired.
The inspector told us to do it from the next Race, so we had no choice but to replace it.

Was the one you received as per Image?
The bremboOEMPin has a pin head that fits into the body.
The umbrella part of this product is large, and I think it has a dress-up effect in terms of appearance.

Was the installation difficult?
It is not difficult at all. Loosen the lower nut while holding the upper hexagon, and remove the nut first.
After that, loosen the upper hexagon and pull out the Pin as it comes loose.
Remove the old grease with parts cleaner, apply new grease to the necessary areas, and then apply the new grease.
It will take less than five minutes to assemble the system in the reverse order.

How was your experience with it?
There is no such thing as lighter because of Titanium. Nothing has changed with Fee Ring.
The original purpose of Wiring was done well, so I give it a perfect score of 100.

[Included Parts:were they on?
There was nothing.

[Was there anything that disappointed you?
No, it is a PivotPin. The only thing I would say is that since it is a PivotPin, the titaniumium coat on the shaft will peel off as it is used.
However, the Material itself of this product is Titanium. Those of Koken and OthersBrand are Titaniumium coat on Stainless Steel.
Yet the price is almost the same, so we chose this product. View detail

I like Jita's Titanium.

It was NORMAL 12 Gram, Jeta 7 Gram. I am satisfied although I do not know the difference in operation feeling by myself. I want Titanium coat to last long. View detail