【KTC】Plastic Pattern Screwdriver Cross Review

I've been using it for years.

The handle is large, so it is not suitable for light turning.
The precision is outstanding, and I guess KTC is made in Japan.
The part to turn with force is also secure, and it is hard to use other cheap tools. View detail

Easy to use

[How is it used?
The size of the Fixing Screw of the Generator Cover is Large, so I purchased the No.3 number because the normal Phillips Screwdriver was almost tarnished.

Was the one you received as per Image?
As shown in the picture, it was bigger than I expected, but it was just right for my use.

How was your experience with it?
As described as a firm Fit to Mt. Screw, it was Firmly engaged and did not feel like it was going to lick at all.
I thought it was comfortable to hold and very easy to turn.
The hexagonal shaft makes it easy to apply Torque, and it is also used as a penetrating driver, so it is likely to be used more often in the future for maintenance of old cars.

[Points to note]
It is difficult to get a sense of size, but for the 1st pc Penetrating Driver, No.1 or No.2 is good.
I chose No.3 because the Screw mountain I use is a bit deep and wide.

How did it compare to other products?
I only had a Phillips Screwdriver, which I didn't know well at Homsen, but it is incomparably better than that.
The ease of use, such as the feeling of fitting snugly to Screw Mountain and the ease of gripping, is good for the price.

【Review】
It was easy to use, as it is a highly rated Driver.
For light maintenance, an inexpensive one would be fine, but for those who do heavy maintenance, it would be worthwhile to have one pc. View detail

Easy to apply force

I bought this to replace the Driver because it was getting tired.
As KTC claims, it has a shape that makes it easy to apply force.
The cross-section is almost square, so I don't think there is any driver that can compare to this product when turning the screw with LargeTorque applied anyway.
On the other hand, once the screw is loosened, when you turn it round and round, it requires a hang to remove it at high speed because it is low geared due to its rectangular shape.
I have a lot of opportunities to turn a stuck Screw, so I wanted a Driver that could hang a LargeTorque anyway, and I like it.
Since it is a Penetrating Driver, it can be used by tapping it with Hammer.
I once beat GunGun to the point of destroying Driver, but I can still use it today without any damage.
The precision of the tip is also well done as only KTCBrand can do, and as long as you choose the right size, you will hardly lick it.
Also, since it is magnetized, it is less likely that the loosened Screw will fall off.
Because of its overall thickness and rigidity, it is difficult to access narrow gaps, but I use different drivers for the right places. View detail

Easy to grip, though.

It is not suitable for twirling.
The accuracy etc. is preeminent, and it is as if it is KTC.
You can turn the part with force without worry.
However, it is a little large pattern to use for motorcycle maintenance.
I'd like to see a small one in the line up too. View detail

KTC is the best

It is easy to grip, the rigidity is high, and it is hard to lick the screw, and it is a first-class product indeed. View detail