【Techserfu】[Repair / Optional Parts] Exhaust Spring 100mm Review

Highly recommended for Long Type!

[How is it used?
By changing the Silencer OnlyMegaphone of NojimaFull Exhaust System on XJR1300C.
Used for the joint of Silencer and Exhaust pipe.


How was your experience with it?
With the SiliconCover, it's 100mm normally, and probably 110mm when extended, no problem.
I'm pulling quite a bit, but so far it's working fine.


How did it compare to other products?
Anyway, I chose this long Spring with SiliconCover for cosmetic reasons.
One Side is a type that can move its neck freely, and it is a guy who can correspond to the type that the angle of Spring hook is attached.

[Points to note]
Be careful not to pull too hard! It will fly off while you're driving. View detail

Thank you for Repair!

I replaced the silicon rubber as it was browned and dirty and discolored, Repair Parts was available. If the price was a little lower, I would like to keep them in stock. View detail

It is diverting to another company's exhaust system, but it is useful for Large

The Kawasaki ZR-7 for Other Company Exhaust System Purchased
We use a manufacturer's exhaust system called P's supply I tried to ask for Repair Parts because one of the springs had come off, but The same one was not available because the manufacturer had stopped making them
So, I was looking for an alternative that would fit the Size and this Part came to my attention
It's from the Muffler maker and comes with anti-vibration Silicon and is not too expensive I'm very happy with it View detail

Expectation of lifetime

We are on the 90th year GSX-R1100 but since Spring was out, I purchased it, but Size was supposed to have matched but it was not before.
View detail