【POLISPORT】Swingarm Protector (1 Set) Review

I think it's good.

[How is it used?
Forest road Gare
Was the one you received as per Image?
as it is (i.e. now)
Was the installation difficult?
Easy
How was your experience with it?
It serves its purpose.
[Included Parts:were they on?
It comes with Sponge as a buffer.
[Was there anything that disappointed you?

Other items that would be helpful
Installation points and hang/Availability and clarity of the Instruction Manual/Points to consider/Items to purchase/Opinions and requests to the Manufacturer View detail

Used on crf250rally

I had a large scratch on the Swing Arm when I ran in a gully with another vehicle.
I purchased this product to reduce scratches as I have just switched vehicles.
The vehicle is CRF250RLYInitial Model.
Installation is easy
It can be installed without removing the shaft of the rear tire.
If you are not familiar with it, it is easier to remove just the nut for the Right Side Shaft.
CRC556 is also good.
The bolt to stop the chain case is too short for the OEM product. A bolt with the same pitch but 5mm longer is required.
Merit can reduce the number of scratches in the galleys.
Demerit will get sand in it, so slips will be made.
I am happy with my purchase. View detail

MY2023 for YZ125X

I had been using the same product on my YZ250FX, so I was torn between it and ACERBIS Magnet type, but I decided to go with this one because of its cost performance and reliability.

Installation is simple and is secured with the included thick Tie Wrap.

If mud gets into the swing arm, it can cause minor scratches on the swing arm, so it must be removed and cleaned periodically, such as after a muddy ride.

This may not be necessary for Motocross, but it is essential for Enduro if you do not want to make the Swing Arm too skinny. View detail

I didn't get to 00.

[How is it used?
It is not compatible, but I bought it to install on my 2000 RM250.
I was expecting to be able to install it on my acquaintance's 2003 RM250, but the result was that I could not install it.
The Axle Block area of the Swing Arm was too large and I could not get into it.

Was the one you received as per Image?
It was higher quality than I expected. It has some thickness and seems to protect the Swing Arm.

Was the installation difficult?
I was unable to install it, but it comes with Tie Wrap, which can be installed by simply tightening it.
There is no need to remove the Wheel either.

How was your experience with it?
I couldn't use it. It's a pity because the product was good.

[Included Parts:were they on?
It came with a Tie Wrap and some sort of cushioning material to attach to the Swing Arm.
There was no Sticker, which is a certain Off product. Surprising.

[Was there anything that disappointed you?
Not particularly

Other items that would be helpful
Installation points and hang/Availability and clarity of the Instruction Manual/Points to consider/Items to purchase/Opinions and requests to the Manufacturer
It looks like it will be attached to RM after '03, so you can divert at your own risk. View detail

good quality

good quality。i love it View detail