【KIJIMA】Stainless Exhaust Band Review

KIJIMA Stainless Steel Exhaust Band

I used to use a different band, but when I tightened it, the bolt diameter was a little thin and it was not strong enough.
After a certain amount of use, it was easy for the screws to be ruined by heat and tightening.
This Band has a slightly thicker Bolt and has no strength problems, so this Band is now used. View detail

Used for I.D. 60.5Φ.

63-68mmSize is used for Exhaust System with inner diameter of 60.5Φ.
Looking at the cost of Bolt's surplus, it would have been better if it had been a little smaller.
However, there is no problem at all in fixing it, so I am satisfied. View detail

Material:Stainless Steel is good

I made a mistake with the size, but I think it is a very good product, Stainless Steel and it won't rust, and considering the burning thing, it is a Material:Stainless Steel exhaust pipe and silencer with band and material:Stainless Steel is a good choice. View detail

Used in SR400

Material:The exhaust pipe and silencer are made of Stainless Steel, so the color of the Plating Exhaust Band is different from the Plating Exhaust Band, but the Material:If the band is made of Stainless Steel, the burnt color will look natural. View detail

easy to get

When I installed YOSHIMURA's Slip-on Silencer, I am a stocky person, and I broke the attached Clamp band by holding the Torque wrench too tight for some reason, perhaps because of the installation angle.
It takes time, but I looked on the Net to order from YOSHIMURA and found that KIJIMA's products are identical to YOSHIMURA's.
It was easy to obtain and inexpensive. View detail