【ACTIVE】Air-Free Banjo Bolt Double Review
Used for GALESPEEDBillet Axial Caliper
Used to install GALE SPEEDBillet caliper.
Necessary parts for integrated Breeder/Hose installation.
Double/single use depending on h-type brake hose routing.
CaliperBlackI wanted to create a unified look, so I chose P1.00Black.
We considered other companies' products, but the combination made by Active and GALE SPEED is a safe choice.
Responses
Other reviews
Brake
I bought this one in response to brembo.
I wanted the Stainless Steel Black, but they don't seem to have it.
Material:Since it is Aluminum, I am a little worried about the Screw mountain with repeated use.
View detail
Easy without air
Brake master which Air collects and is difficult to escape can easily perform Air venting quickly with this product.
When unplugging the air, it is useful to have an 8 mm Double-end Wrench.
View detail
Exchange of Fluid is comfortable!
ACTIVEActive : Air-Free Banjo Bolt Double
Bolt pitch : P1. 25Doublewith Crash Washer x 3pcs. Material : Aluminum / Color : Plated / Bolt diameter : 10mm / Aluminum Washer Thickness : 1mm
NORMAL's Banjo is thick : Because it was 8 mm, I added Washer to Quantity : 1 Set of 4pcs. Added and installed.
Banjo of 10 mm Thick can be installed with this set alone.
View detail
"It is a mounting state in a handle clamp genuine height of 1cm up and 1cm back. The wheel is turned until full to the right. Since it returned a little when taking a photograph, there is a gap, but the actual condition is that there is 1cm or less gap. A
"It is a mounting state in a handle clamp genuine height of 1cm up and 1cm back. The wheel is turned until full to the right. Since it returned a little when taking a photograph, there is a gap, but the actual condition is that there is 1cm or less gap. A tank is likely to be dented, if I fall down. A measure is required." View detail
In carrying out the specification change of the caliper from Brembo 40mm CNC caliper to the radial mount of 108 mm of Brembo, I purchased in order to set a banjo and to exchange for a new product. Since air-bleeding is also attached, I would like to carry
In carrying out the specification change of the caliper from Brembo 40mm CNC caliper to the radial mount of 108 mm of Brembo, I purchased in order to set a banjo and to exchange for a new product. Since air-bleeding is also attached, I would like to carry out air-bleeding by this without using the one in the caliper side. It is said that a thread part may become useless if how to apply torque is wrong and doing repeatedly. It is cheap for caliper protection. View detail