【OUTEX】Clear Tubeless Kit Review

Best item and fast delivery

Easy website to buy item suit my bike. But i dont know why need 100 word at the review, so i have to write abcdefghijklmnopqrstuvwxyz View detail

No more carrying Tubes.

MOTARDWheel was able to get a used one.

Tire was also no good, and Puncture and Tube were also no good, so we installed the Tube Eliminate Kit while we were at it.

Spoke nipple was also dirty with rust, and the welds on the rim had been roughed up with a grinder, so it took a long time to prep the surface.

Rim with Stages (about 5 cm long) I roughed it up with Leutor to eliminate the (about 10 cm) Next, the Grinder was further sanded with a Wire cup brush. Next, I used a Wire cup brush on the Grinder to make it shallower. (about 12 cm) The rest was smoothed by tracing the wire cup brush area with a BrassCup brush.

The nipple is also brushed all around with a wire cup brush, then brushed with a Brass Cup brush to remove scratches. Finally, degrease the nipple with a cleaning thinner and remove iron dust with an air gun. In addition, the Instruction Manual says to wash with Alkali detergent and dry. However, I didn't like rust, so I wiped it with Brakes cleaner.

The rest of the work was done as per the Instruction Manual.

Assembling the Tire was easy with no Tube.

After 3 days of air injection at 3 kg/cm, we assembled the large sturdy unit into the vehicle and completed the assembly. View detail

First Tubeless Processing

I purchased ZETA's MOTARDWheel and converted it to Tubeless!
It was the first time for me to do it, but I was able to do it after reading the Instruction Manual and watching the video!
The Nipple was worked on as is without modification, but there was no leakage!
Be careful as it is a one shot deal! It was Large sturdy even if it bent a little or got air in it! It was easy to do because it came with special gloves!
I don't know how many years it will last, but if it lasts long enough, it might be a good deal! View detail

Perseverance is a must.

It was quite a large job, starting with the preparation of the wheel (the work content changed depending on the wheel's condition), double-sided taping, and protective taping.
(Some of the Wheel was in bad shape.)
Double-sided tape pasting is very difficult.
(I wanted to put it on Beauty but couldn't. If I could have stuck it there, it would have been Large sturdy. (I wanted to stick it to Beauty but I couldn't, but Large was tough enough to stick it there.)
Protective Tape could be applied to Beauty if applied calmly.
It took a lot of patience, but I am happy that I was able to make it Tubeless and wear Radial. View detail

Purchased for CB750four

Purchased both Front and Rear.
I started with the rear tire first and followed the instructions to install it without any problems.
A year later, I installed it in conjunction with the replacement of the front tire, but the joint between the rim and the double-sided tape was not properly connected.
It did not work and I gave up on this one. Maybe a year has passed and the adhesive strength of Tape has weakened.
You may
I couldn't see any difference in the ride quality after installing the Tubeless.
The cost is not so good, because it is more expensive for the
The satisfaction is the DIY sense of accomplishment and the relief when the Tire is inflated and there are no leaks. View detail