【ADVANTAGE】Reinforced Clutch Spring Review
feel well
It is not as heavy as it sounds, but just right and easy to handle.
I don't think there is any particular problem with durability.
If you want to enhance it further, you can also modify the disc, plate, etc.
I think it will be better.
Responses
Other reviews
Kitamura Kobo and Quantity:Mounted with Set
The intake/exhaust and CPU are also being tweaked, so it was installed anyway.
There was no heaviness or anything with Hydraulic Clutch in it.
View detail
Used for YZ125X
The length of Yamaha OEM clutch springs changes as you use them, and this probably leads to the unevenness in the amount of pressure plate push-up = poor sharpness. I installed this product, which is made of the same material as the Valve Spring. I found a little difference in the length of the new spring, so I shaved the long one with Sandpaper (it is hard to shave it off because it is hardened) and installed it with the shortest one. The sharpness seems to have improved a little after the test run. By the way, the same product was also installed in TT250R, and even after 10,000km, there is no change in length, and the operation is smooth and half clutch is easy to do. I will report back after seeing the progress over a long period of time. View detail
Effective
The direct feeling when opening the axel has increased. The clutch may be heavier, but I didn't notice it. View detail
I don't know because the OEM was screwed up.
OEMClutch started to slip, so I replaced it at the time of ClutchOH.
Spring length is a little long? The OEM was not so bad?
The Clutch is now a little heavier, but no longer slips, and the feel when connected is easy to grasp.
As with all parts, they are often replaced after they are worn out, so it is difficult to say whether the parts are purely effective or not, but I think it was a good thing.
View detail
Satisfied with the quality and performance beyond the OEM Product!
I installed it on the SEROW225 whose Clutch was getting low.
Since I was recommended to exchange the combination with the Retainer of Kitamura Workshop, Quantity:Purchased in a set and built in.
I don't know the percentage of which one contributes more than the other for the above reasons, but I'm considerably less frustrated with the Clutch than I was before the swap.
I'm happy with the sharpness and the way it moves when I apply the power.
It's a bit more expensive than the OEM Product, but if it works so well, I'd choose it for my next replacement.
View detail