• Home
  • Product reviews
  • Motorcycle Parts
  • Bodyworks
  • Fairings
  • Lower Fairings / Belly Pans
  • The finish is as good as I expected.... (A-TECH: Under Cowl SPL)
steps-review.png

【A-TECH】Under Cowl SPL Review
Under Cowl SPL A-TECH
A-TECH
Under Cowl SPL

Fits: KAWASAKI Ninja H2R, KAWASAKI Ninja H2

sh kim
5/5

The finish is as good as I expected.

The finish is as good as I expected. The H2 model is popular in Korea. There's a lot of interest in undercolls. I'm also using a-tech products I have placed an order. The overall packaging of the cowl is well done, and the clear layer is also good. The carbon pattern is also well expressed. It will be installed after PPF film construction. Thank you.

Show origin

Responses

Other reviews
Under Cowl SPL
A-TECH
Under Cowl SPL
Japanese Webike user
3/5

To

After purchasing through a dealer, I installed the bracket at the back of the water pump side and the bracket at the exhaust pipe on the right side by myself. The bracket on the back side of the body is 10N on the water pump side and 12N on the clutch cover side, so we tightened the Both Sides by inserting the scissors with a large size Flat Washer. I had to quickly put it on or drain the oil and coolant once. Especially around the catalytic converter and exhaust pipe, it gets hot.

After installation, the exhaust pipe on the right side of the Idling got hot very quickly, so I modified the bracket, washer, collar, etc., and adjusted the position of the pipe.

After that test run, the wind entered during driving and there was no problem with the exhaust pipe on the Right Side, but the Chain on the Left Side interfered with it. I adjusted the position again, shifted the position of the collar, and offset it to the Right Side. The next test run, there was no interference, but the exhaust pipe on the Right side did not have enough clearance, and a stone was caught between it and the Heat Insulating Material, If you smell burning smell when idling, it would be better to check it once. View detail