【HURRICANE】Hexagon Type Setback Holder Review
Good to be able to replace the hose without changing it.
Although the Handlebar is just a little bit closer to the front, I can feel quite a difference!
It is easy to replace the hose cable without changing it! All you have to do is to be careful not to damage the nut when removing and installing the bolt.
It looks better and is better positioned!
Responses
Other reviews
Handlebar cannot be installed without it.
I bought this Holder together with the Top Bridge for my ZZr Bar handle, and since the Top Bridge is also a HURRICANE, I was able to install it without any difficulty. I am satisfied with the position, not too far and not too close. View detail
Recommendation for city driving
He is 174cm tall.
Maybe because I rode with NORMALSpec. for 10 years,
10mmUp and 20mmBack were experienced more than expected.
It is easy to drive with good arm strength and easy to drive, and is also recommendation for city driving.
I felt it was cost effective for me.
View detail
High quality & improved the feel and ride posture of honda cb1100rs
The bar risers are 20mm backwards (nearer to rider) and 10mm higher. eventhough the difference looks small, but after installing it, the riding posture and stance is totally changed! the ride is much more comfortable now (without excessive bending over to hold the handlebars). The fit and finish, and very high quality product, they also provided the nuts cap. highly recommended! View detail
Position has become so much easier!
Although the change in position is only slightly more than NORMAL, the effect is immensely LARGE.
In my case, the Normal position did not feel comfortable, and after driving for more than one hour, my arms were tired and I was concerned about stiff shoulders. However, I also changed the seat together with the Normal position, and I assume that the Seat height is slightly higher than the Normal position because the Cushion is higher.
The price is high, but considering the functionality, I wish I had done it sooner.
View detail
’19CB1100EX Unable to fit...
It was listed as compatible with CB1100EX up to 16 years old.
I tried to install it on my '19 CB1100EX just to see what it would do.
The holes in the Meter Bracket (HondaOEM Product version:37120-MGC-JB1) that will be co-tightened are
OEMHolder's M8 diameter does not pass through this Holder's BoltM10.
Declined to apply...
I suppose it would be possible to widen the hole with a reamer.
We have decided not to do so for the time being.
So bad
View detail