【BATTLE FACTORY】Front One-Touch Stand Review
During car wash and wheel maintenance
It is designed for mini bikes, but the stem hole diameter is suitable, so I used it on the MT-10. Naturally, the Rear is supported by the maintenance stand. It takes a lot of force to raise it, but it works. However, it is not suitable for maintenance that requires a lot of force because it tends to wobble. In that case, it is definitely more stable to use a normal front stand.
Also, if the foot hangs at an angle halfway, the STAND of the Rear may gap.
Responses
Other reviews
lacking in stability
It lifts up, but while lifting it up, it shifted forward and fell off.
I'm glad I didn't remove the Tire.
I replaced it with a higher one to be raised by the same Manufacturer's Stem.
Maybe I was not using it properly, but I didn't understand it because it was not explained in detail.
Maybe people without knowledge should not use it.
View detail
I bought it for Race
[How is it used?
I used it to put on Tire warmer at Circuit.
Was the one you received as per Image?
It was just as Image.
How was your experience with it?
It is very easy to install and remove, so it is very useful in Circuit!
[Points to note]
Can be installed on any commercial vehicle body.
View detail
Good quality
A little expensive but good quality. View detail
Easy, easy to lift
It is a little heavy, but can be lifted easily.
It can be folded so it takes up little space in the Transporter.
The stability is there, too.
View detail
Commercial groms can be used without problems!
I bought this for daily maintenance and to wrap the tire warmer at the circuit. At first I thought I would have to take the headlight off to use it, but I had no problem at all and was able to lift it easily. Moreover, it can be folded up when not in use, so it can be stored without taking up too much space.
It was an excellent product.
View detail