【DAYTONA】Insulated Glass Wool Review
Purchased for attaching to the inside of an external Under Cowl
I noticed that the part where the Exhaust System was in contact with the external Under Cowl was slightly melted, so I hurriedly purchased this product. I drove several hundred kilometers after applying the product, but I did not see any deterioration of the Under Cowl due to heat. It helped me a lot. At this point, I would give it an All 5. I hope it will last for a long time without any deterioration.
Responses
Other reviews
It comes with adhesive Seat and has a high heat resistance temperature.
Used for Heat Guard on DUCATI 848.
In the 1098 series, the Exhaust System meets under the thigh of the Right leg, so it gets unthinkably hot in a Japanese car.
The external Carbon heat guard has already been burnt out.
I purchased this product to stop further progression.
There were also overseas products, but DAYTONA is still the safest choice.
With adhesive Seat, itself heat resistant to 100°C and not in direct contact, it was perfect for my needs.
Cutting with Scissors is also easy, and the glass fiber does not scatter that much. (Mask is recommended).
The adhesive was strong enough, I have used it for several months and nothing has peeled off.
It used to be hot even through the Gloves, but now it is not hot at all and I can even touch it a little with my bare hands.
It is not expensive and is a good product.
View detail
Insulation Seat
I purchased this product because when I replaced the Tank with another color Tank on my SR400, the OEM Insulated Seat was not attached.
The texture is thinner and harder than the OEM insulated Seat, but it does not look cheap.
View detail
It is used for the exhaust pipe of the Exhaust System.
This Glass Wool is used for the exhaust pipes of the Exhaust System. It is relatively inexpensive and the material is easy to roll, so it is easy to work with. View detail
DIY Heat Guard Production (・∀・)
When I was looking for Heat Insulating Material to make Heat Guard.
This product has been found (・∀・)
It is less expensive than similar Insulation Glass Wool.
The heat resistance temperature is relatively low at 200-350°C, but it was sufficient for our purposes.
And the release paper on the back is easy to draw lines on, and it's just the right thickness.
I think it was easy to process. (Translated by ω-) b
If I had to pick a favorite, I'd say the Large width would have been better.
View detail
At least it's insulated.
I bought it to wrap around my 2-stroke Chamber.
Wire and wire twister are necessary. It is necessary to make the appearance beautiful. It becomes a heat-shielding, but I am not sure whether the performance has improved.
View detail