【SPHERE LIGHT】LED headlight for motorcycle RIZING3 H9/H11 Review

Sphere LightGod of thunderG3

I had been using God of thunder 3 lights, but I had a hard time seeing at night when driving through mountain passes. I can drive on mountain passes without any worries. View detail

If you want to replace Valve, this is the one!

RC390 (2021 model year) The OEM Halogen Headlight was too dark, so we replaced it with this LED Headlight Bulb.
The quality and texture of the product is perfect.

The process is similar to a typical Valve replacement, such as removing the OEM Valve from the Coupler, removing the ValveBody and assembling it in the reverse order as when the new Valve for the LED was removed, and putting together the Wiring.

However, there is a gray cap on the reverse side of the headlight of the 2021 RC390, which may slightly interfere with the aluminum heat sink. Therefore, we installed the headlight by rotating the LED bulb first and then pushing the cap in, while sticking the cap halfway in.

When I purchased this product, I was not sure if I could afford this price for two Valves since the 2021 RC390 has two lights.... But when I installed it, I was very impressed with the brightness.
Both Hi and Lo can be installed with the same work and no modification, and the brightness of the product is highly satisfactory with no complaints. View detail

Bright and safe

I use it on a GSX1300R HAYABUSA 08 High beam.
I introduced it because of the limitations of Halogen in NORMAL.
Dramatic change in brightness when driving at night, allowing you to drive with peace of mind. View detail

Brighter than expected. But ProjectorLamp needs attention.

I installed it while adjusting the angle of the pedestal & heat sink after carefully reading the instruction manual. The light is as bright as the low AbsoluteHID. I installed it as specified in the instruction manual, but the light is Heart type, but it illuminates where I want to see in Curve at night, so I think it is OK.
There are some points to note when installing the H9/H11:The Valve must be inserted and rotated to fix it in place. If the base and heat sink adjustment screws are not tightened, the valve will spin inside and will not be removed, and the entire light case will have to be replaced.
Well, 35W was brighter than I expected, so I can replace the low if I like using it. View detail