【DAYTONA】Sensor Fitting for Oil Temperature Review

Oil temperature sensor

YOSHIMURAPROGRESS2Multi-temp meter is installed on CB400Four.
If the sensor is attached to the oil drain bolt, it must be removed every time the oil is changed.
I bought this one because the sensor is taken from the PassCap under the Point cover.

Sensors are
Sensor Type-C for PRO-GRESS is compatible. View detail

For Oil Temperature Meter Installation

Used to install DAYTONA AQUAPROVAOil Temperature Meter.
Remarks… Use the one that matches your car model and Sensor fittingSize. View detail

Used for AquaPROva Oil Temperature MeterFitting

Oil Temperature MeterDrain bolt is indispensable for fitting. No problem for installation since it is specially designed for this purpose. It may be better to purchase several for long-term use and deterioration. View detail

Oil temperature sensor screw

Use model honda supercub 50 2009. It should be noted that the sensor is divided into two parts. It needs to be purchased separately from the heat transfer probe and needs to be used with a daytona special probe. The probe wire groove terminal and the oil temperature electronic meter terminal use the daytona oil temperature sensor screw. There is no oil leakage failure. Use model honda supercub 50 2009 Need to pay attention to the sensor is divided into two parts, separately from the heat transfer probe to buy Need to be used with daytona special probe, probe slot terminal and oil temperature electronic watch terminal No oil leakage occurred with daytona oil temperature sensing screw(translated by Google Translator) View detail

The price is just right

I bought this for the connection of the Daytona AquaClover hot water thermometer
Installation is finished only by replacing it with a NORMAL DRAIN bolt, but it is not necessary to replace the hot water thermometer's After removing Wiring of the thermometer because Wiring is connected to the Drain bolt, it is not necessary to remove the Wiring of the thermometer If you don't have it, the cord will be disconnected because it will go round and round After removing the Terminal, put the Wiring together with the Drain bolt on the Round and You have to turn it round and take it off View detail