【SK11】Long Spinner Handle Review
Axle Shaft, etc.
I bought this to replace the Wheel on my ZrX1200R.
I used it to loosen an Axle Shaft and it was easy to apply force.
Other uses would be useful, such as loosening the nut on the wheel of a car.
Responses
Other reviews
Used to remove the Clutch of LETS4Palette
When removing the clutch outer of the LETS4Palette, the nut holding the clutch outer in place was used to loosen it.
I was able to loosen a nut that did not loosen at all with the 150~180mmRatchet wrench I usually use.
Because of its long overall length, it is a convenient tool that can be used to apply large torques even by human power.
View detail
Necessary and sufficient performance
[How is it used?
It is useful for loosening axle shafts and steering nuts on motorcycles.
It can also be used to replace Tire on cars.
Was the one you received as per Image?
It was just as Image.
I appreciate that SK11 has a pretty good selection of products with excellent Cost performance.
There are some spec. for reduction in cost, such as no holes in the handles and no Knurl processing to prevent slipping, but I think it is sufficient.
I also use a Torque wrench to hang Torque.
How was your experience with it?
It is quite effective for Bolts and Nuts that do not loosen or have high Torque applied to them.
Basically, it is used for bolt and nut of the undercarriage that is stuck, but it is easy to work with thanks to its length.
Socket tools are mainly aligned with a 3/8 insertion angle, but for those that are unlikely to come loose, 1/2Socket is prepared in advance and used.
How did it compare to other products?
The Spinner Handlebar of this length made by other well-known manufacturers is quite pricey, so it's nice to know that it's cosmetically sound.
View detail
Safe even at high Torque
I use it to loosen axle nuts on my motorcycle and also to change tires on my car. I am satisfied that the practical strength is sufficient and I do not have to worry about it breaking. View detail
the ultimate weapon
The ultimate weapon for turning a Bolt that won't come loose.
I don't have a lot of arm strength, so I tend to use longer tools than others.
Basically, it is used for Bolt/Nut of the undercarriage that adhered, but thanks to the length, it is easy to adjust the force.
Socket tools are mainly aligned with a 3/8 insertion angle, but for those that are unlikely to come loose, 1/2Socket is prepared in advance and used.
There is no hole in the handle and there is no Knurl processing of the non-slip, and some Spec. for Reduction in cost is seen, but Platingetc. finish is also good overall.
The Spinner Handlebar of this length made by other well-known manufacturers is quite pricey, so it's nice to know that it's cosmetically sound.
View detail