【HURRICANE】Hole Plug for Screw Hole M8 Review
Bolt hole concealment
When the tandem footpeg of the CT125 is removed, the bolt holes are exposed, and if water or other substances get into the holes, they can cause rust.
Responses
Other reviews
Screwfor Hole
I didn't check it carefully, but it seems to be an M8 Screwfor Hole, not a product for filling a hole of M8Size. So the body is around M6 size.
It does not appear to fill the M8Size hole.
View detail
I use it to prevent Rust in Screw holes.
I use this product to cover up the screw threads and to prevent rust. It is cheap to cover and comes off easily, so I now have a Habit to inspect it from time to time! View detail
Ideal for covering up holes, but difficult to remove.
It is used for the screw hole of Plate which is exposed with footpeg position change. Because this is much cheaper than hiding with an ordinary Bolt, and the appearance seems to be good, I tried it.
The diameter of the head is almost the same as the screw hole and it is very neat. The protrusion on the side goes in easily in the inserting direction, and there is no need to worry about it coming off due to vibration as it is designed to catch on the screw thread in the pulling direction.
After that, the footpeg was finally installed in the same position as the original and this Cap was no longer needed, so I tried to remove it, but this time I had a problem. However, the Slotted screwdriver was not able to be put in at all because of the Smallness of the head diameter and the adhesiveness.
Fortunately, the hole I used is penetrating, so I was able to push it in with a driver and pull it out from the back. If the hole is non-Penetrating, you will need to drill a hole with a drill bit and cut it out with a cutter, etc.
Before you use it, you should really think about whether it's strong enough to cover it up and Large before you use it.
View detail
Unnecessary Screw filling up
I removed the Left Side Mirror for commuting Scooter as it gets in the way because it slips through the traffic jam, but I tried using it for filling in the remaining M8Screw hole. It has a burr and is plugged into the Screw mountain when inserting it so that it can not be taken easily. I think that it is very convenient because it helps to protect Screw holes which are no longer used.
However, it is slightly troublesome as the head is Small when you remove it.
View detail