- Home
- Product reviews
- Motorcycle Parts
- Handles & Control Parts
- Handlebar Kits
- To replace the Handlebar on a 2021 MT-09SP.... (HURRICANE: FAT Swallow Handle Kit)
【HURRICANE】FAT Swallow Handle Kit Review
To replace the Handlebar on a 2021 MT-09SP.
I wanted to do something about my wrist getting sore in the second half of touring. and hanging angle of the handlebar? I wondered if it was a problem with the handlebar's aperture and hanging angle, so I installed this swallow-type handlebar, which was sold exclusively for the car model.
Clutch Cable is a special product for installation (this is Quantity):Before pulling out the old Cable, fix the lever side of the new Cable to the lower end (ClutchCase side) with a Tie Band as shown in the 5th image, so that you can pull out and turn the Cable at the same time. You can kill two birds with one stone.
The OEMClutch Cable is fixed behind the Headlight, so it is a little troublesome to remove the fixation here.
The HandlebarBody can be installed without any particular problems, and our vehicle has the Handlebar Post position lowered by 3cm, but even when installed at the desired angle, it fits without interfering with the LimitTank.
The replaced clutch wire must be secured around the handlebar with a tie band or it will interfere with the meter.
As for the position, it was slightly difficult to raise the Shift Pedal because it was tilted forward so much, so the pedal angle of the Rear Sets was adjusted.
Also, I went on a Touring trip of about 300 km after the Handlebar replacement, and I felt that it turned out well for me because I became more conscious of my Knee grip so as not to hold the Handlebar down.
However, due to the fact that it was my first touring in a month and my usual lack of exercise, I ran out of energy in the latter half of the day and had to hold down the handlebar more often, so my shoulder area was sore the next day.
(The pain in my wrist was the same, so I think it was caused by the way I hold the handlebar.)
Also, this is not an issue with the MT-09SP, which is a NAKED model with a MOTARD or STREETFIGHTER-like position, but when riding on the highway with a headwind or when overtaking, the air resistance is large or it feels like it is going to float. When the air resistance is large or it feels like it is going to float up when there is a headwind or when overtaking at a temporary court speed+α, and when I get down, the high position of the handlebar made it a very hard position to be in.
Lastly, the position of the handlebar is a matter of personal preference, so it is difficult to judge the position of the handlebar from the values on the product page alone without actually seeing it installed.
เพื่อทดแทนแฮนด์บาร์ของ MT-09SP ปี 2021.
ฉันอยากจะทำอะไรสักอย่างเกี่ยวกับอาการเจ็บข้อมือในช่วงครึ่งหลังของการเดินทาง และมุมห้อยของแฮนด์? ฉันสงสัยว่ามันจะเป็นปัญหากับรูรับแสงของแฮนด์และมุมแขวนหรือเปล่า ดังนั้นฉันจึงติดตั้งแฮนด์แบบ Swallow-type ซึ่งจำหน่ายเฉพาะรุ่นรถยนต์เท่านั้น
สายคลัตช์เป็นผลิตภัณฑ์พิเศษสำหรับการติดตั้ง (นี่คือปริมาณ): ก่อนดึงสายเก่าออก ให้ยึดด้านคันโยกของสายใหม่ไปที่ปลายล่าง (ด้านสายคลัตช์) ด้วย Tie Band ดังภาพที่ 5 เพื่อให้ คุณสามารถดึงออกและหมุนสายเคเบิลได้ในเวลาเดียวกัน คุณสามารถฆ่านกสองตัวด้วยหินนัดเดียว
สาย OEMClutch ได้รับการแก้ไขหลังไฟหน้าดังนั้นจึงเป็นเรื่องยากเล็กน้อยในการถอดการยึดออกที่นี่
สามารถติดตั้ง HandlebarBody ได้โดยไม่มีปัญหาใด ๆ และรถของเรามีตำแหน่งโพสต์แฮนด์ลดลง 3 ซม. แต่แม้จะติดตั้งในมุมที่ต้องการก็ยังพอดีโดยไม่รบกวน LimitTank
สายคลัตช์ที่ถูกเปลี่ยนจะต้องยึดไว้รอบๆ แฮนด์จับด้วยสายรัด ไม่เช่นนั้นอาจกีดขวางมิเตอร์ได้
สำหรับตำแหน่งนั้น การยก Shift Pedal นั้นทำได้ยากเล็กน้อย เนื่องจากเอียงไปข้างหน้ามาก ดังนั้นจึงมีการปรับมุมแป้นเหยียบของชุดหลัง
นอกจากนี้ หลังจากเปลี่ยนแฮนด์รถ ผมยังไปเที่ยว Touring ระยะทางประมาณ 300 กม. และรู้สึกว่ามันออกมาดีสำหรับฉันเพราะผมเริ่มใส่ใจกับการจับเข่าของตัวเองมากขึ้น เพื่อที่จะไม่ต้องกดแฮนด์ลง
อย่างไรก็ตาม เนื่องจากเป็นการทัวร์ครั้งแรกในรอบหนึ่งเดือนและขาดการออกกำลังกายตามปกติ ฉันจึงหมดพลังงานในช่วงครึ่งหลังของวัน และต้องจับแฮนด์บ่อยขึ้น จึงปวดบริเวณไหล่ วันถัดไป.
(อาการปวดข้อมือของฉันก็เหมือนเดิม เลยคิดว่าน่าจะเกิดจากการจับแฮนด์)
นอกจากนี้นี่ไม่ใช่ปัญหากับ MT-09SP ซึ่งเป็นรุ่น NAKED ที่มีตำแหน่งคล้าย MOTARD หรือ STREETFIGHTER แต่เมื่อขี่บนทางหลวงที่มีลมปะทะหรือเมื่อแซงจะมีแรงต้านอากาศสูงหรือให้ความรู้สึกแบบนั้น กำลังจะลอย เมื่อแรงต้านอากาศมีมากหรือรู้สึกเหมือนกำลังจะลอยขึ้นเมื่อมีลมปะทะหรือเมื่อแซงด้วยความเร็วคอร์ทชั่วคราว+α และเมื่อลงจากตำแหน่งแฮนด์สูงทำให้เป็นตำแหน่งที่แข็งมาก ที่จะอยู่ใน
สุดท้ายนี้ ตำแหน่งของแฮนด์บาร์เป็นเรื่องของความชอบส่วนตัว ดังนั้นจึงเป็นการยากที่จะตัดสินตำแหน่งของแฮนด์จากค่าบนหน้าผลิตภัณฑ์เพียงอย่างเดียวโดยไม่ได้เห็นการติดตั้งจริงๆ