【KIJIMA】Helmet One Touch Clip Review
I have been using it for many years on my Helmet for street riding.
I use it on my ARAI full face helmet for street riding, and it is convenient for me because I can attach and detach the helmet's chinstring with one-touch, but I have to remove the Snap button on the chinstrap belt, However, the Snap button on the chinstrap belt has to be removed, so it is a bit tricky to install. The Gold Parts are made of steel, so rusting is a bit of a problem.:I would be happy with Large change if they commercialize it in Stainless Steel (even if the price is higher, I would still buy it...). I would be happy to buy it if it was made in Stainless Steel.
Responses
Other reviews
It is useful for attaching and detaching the helmet!
[How is it used?
ARAI's Helmet is a type of helmet that is fixed by putting the chinstrap through the D Ring, so it takes time to put it on and take it off one time at a time.
KITACO and DAMMTRAX's could not accommodate the width of ARAI's chinstrap, so the only option was KIJIMA.
Was the one you received as per Image?
I thought the Black part was Plastic, but Material:It was Rubber. I think the texture is not bad, even if Steel is unavoidable.
Was the installation difficult?
If you do not bend the bracket between the belt and the chinstrap, the plastic part of the chinstrap will get caught and will not go through. It requires some ingenuity. I used other people's installation as a reference.
How was your experience with it?
If it is so convenient, I wish I had used it earlier. Some people say that the excess string becomes like a whip when cruising at high speeds, but if you fix it with the original plastic part, it will fit with no problem at all.
[Included Parts:were they on?
None in particular, and no Instruction Manual is available, which is unfriendly.
[Was there anything that disappointed you?
Nothing in particular,
I think it will eventually rust because the material is steel, but if it were made of stainless steel, there would be nothing to say.
▼Material even if a little expensive:I would really like you to make a Stainless Steel product. In that case, it may be difficult to process Bracket, but ….
View detail
Required processing
The one-touch made it easy to attach and detach the Belt, but the part where the Belt passes through is too narrow and the Button attached to the Belt does not pass through. View detail
One-touch with this
I replaced the chinstrap on my helmet with a one-touch. The other day I went on a long touring trip and noticed that I was not wearing a chinstrap and managed to tie it through the ring with my left hand, but I was reminded that it was dangerous to use a large clip while riding and I remembered that KIJIMA has a one-touch clip and ordered one. I thought about it, and this was the third time I had ordered one. When I looked at the delivered product, I saw that it was exactly the same as before. The installation is easy for anyone. As for the quality, I think it would be easier to install if the claw that locks the clip by pushing it in was longer and could be adjusted in about three steps. View detail
The string is easy to pull out.
I am afraid to attach the strings later by Sliding them without sewing them, but they can fall out.
A soft type of string may slip through the gap and lead to an unexpected accident.
I ended up sewing it up and using it so that there was no Gap.
View detail
That's too bad
For one thing, I was surprised and a bit troubled that the Instruction Manual was nowhere to be found.
One, I made the mistake of buying it without looking closely at the impressions.
I did it as I saw fit, but alas, I did not use it.
I tried to install it on an ARAI RX-7X, but when I put the string through the bracket on the Male side and folded it back, the Button hit it and did not go through.
I also tried with SHOEI's J-Force ? (25mm string), but the Male side also did not go through because the Button was in the way.
View detail