【amon】Oil Pan Review
I thought it would be useful for coolant replacement since it is 8L Size.
I wanted a larger size than the Oil Receiver I have been using.
I thought 8L Size would be convenient to catch the coolant that pops out when replacing coolant.
The length did not change from the current one by a large amount.
The deep bottom of the unit is designed to fit the 5L Size inside to create a wall to catch the coolant that pops out.
The workability seems to be good.
Responses
Other reviews
Light and affordable Large size
It is light, reasonably sized and inexpensive, so it is very useful. View detail
Oil receiver on front fork.
Used to catch oil during front fork overhaul.
It's nice and reasonably deep.
I wish it was a little longer.
View detail
I'm glad I got the Large size.
I purchased the 8L size thinking that it would be too large for my VTR250, which can only drain about 2L of oil, but when I used it, I found that it was surprisingly easy to dump oil (it does not spill even if you shake it when you hold it), so I was right.
Note that the vehicle body is in Maintenance Stand with the Rear raised; if it is left in Side Stand, it will not be high enough.
View detail
Add nothing, subtract nothing.
Nothing fancy, just Material:Plastic Oil Receptacle.
No fancy features or appearance at all.
I used to use a dish drainer that I no longer needed, which was convenient because of its deep bottom, but after all, I had been using it for almost 30 years and was becoming concerned about hydrolysis over time, so I bought this.
It would be a tragedy if, after receiving the waste oil, the container turned into a BALI dick during transportation! It would be a tragedy if the container turned out to be a "BALI COCK" during transportation after receiving the waste oil.
The dish drainer is white in color, so the waste oil stains stand out and cleaning was Large strange, but with this container, I don't have to clean it in the first place.
It would be enough to just wipe it down and stand it up on its side.
The dish receptacle was made of scrap metal and cost zero yen, so it's not a good comparison. Oil Pan" The "Guide" groove at the end of the unit makes it easy to dispose of oil, as one would expect from a company that calls itself a "Guide" company.
I have a 20L can with a funnel stuck in it to collect waste oil, and it is definitely easier to dispose of.
Thanks to its large area, it is designed to be low in height, so it is also a recommendation for those with low exhaust pipes.
On the other hand, the shallow bottom makes it easy to spill when moving with waste oil.
It is better to buy as large as the height allows.
View detail
Easy to use
I bought it at Oilfor Replacement.
At first I used it for Oil replacement, but after that I use it for Chain cleaning and parts cleaning.
It's made of plastic, but it's thick and elastic, so it won't break even if you handle it roughly.
The large size is just right so that it does not get in the way when stored away.
It is convenient to have one.
View detail