- Home
- Product reviews
- Motorcycle Parts
- Brakes
- Torque Rod
- Shinobu Sen Rear Torque rod... (NA Metal Craft: 3D Rear Brake Torque Rod)
【NA Metal Craft】3D Rear Brake Torque Rod Review
Fits: KAWASAKI Ninja1000, KAWASAKI Z1000
Shinobu Sen Rear Torque rod
We stocked RearTorque rods from Shinobu Sen.
It is almost a visual obsession!
Dare I say, lightweight? (^^)
Is this Torque rod as accurate as the OEM Torque rod?
OEM was quite hard and used SmallHammer for removal.
The external Torque rod did not go in easily.
But since I had already removed it, I put it in by tapping hanghang with Hammer while checking the insertion angle.
Remove it with no care and install it with the latest care to put it in!
Finally, the specified Torque 3.5kgf-m is installed using the Torque wrench.
The rest is done by applying a split pin to prevent ha-gap!
Except for the difficulty of removing and inserting, I think it is an easy task even for beginners. (^^)
ชิโนบุเซ็นหลังทอร์คร็อด
เรามีแท่ง RearTorque จาก Shinobu Sen
มันเกือบจะเป็นความหลงใหลในการมองเห็น!
ฉันกล้าพูดเบา? (^^)
แท่งแรงบิดนี้มีความแม่นยำเท่ากับแท่งแรงบิดของ OEM หรือไม่
OEM ค่อนข้างยากและใช้ SmallHammer ในการกำจัด
ทอร์คร็อดภายนอกเข้าไปได้ไม่สะดวกนัก
แต่เนื่องจากฉันถอดมันออกแล้ว ฉันจึงใส่เข้าไปโดยแตะที่แฮงแฮงด้วยค้อนในขณะที่ตรวจสอบมุมการใส่
ถอดมันออกโดยไม่ใช้ความระมัดระวังและติดตั้งด้วยความระมัดระวังล่าสุดเพื่อใส่เข้าไป!
ในที่สุด แรงบิด 3.5kgf-m ที่ระบุจะถูกติดตั้งโดยใช้ประแจแรงบิด
ที่เหลือก็ทาด้วย Split Pin เพื่อป้องกัน Ha-Gap!
ยกเว้นความยากในการถอดและใส่ ฉันคิดว่ามันเป็นเรื่องง่ายแม้แต่สำหรับผู้เริ่มต้น (^^)