【DAYTONA】Reinforced V Belt Review
Fits: SUZUKI Address V100, SUZUKI Address V100, SUZUKI Address V100, SUZUKI Address V100, SUZUKI Address V100, SUZUKI Address V100, SUZUKI Address V100, SUZUKI Address V100, SUZUKI Address V100, SUZUKI Address V100, SUZUKI Address V100, SUZUKI Address V100
Good Daytona belt
Very hight quality and texture is good Satisfy when used it for daily About Size is correct for v100 Cost performance and comparison with other products: Daytona belring is one of the best in the market Good service for worlwide shipment packages About the feeling of use: very satisfied
Responses
Other reviews
nice belt
Fits perfectly on the Japanese scooter Suzuki Address 100, the quality of the belt is at the highest level, the maximum speed and start have become much better, the belt reaches the same radius, it is clear that it is of good quality, well packaged, I am grateful to the seller, I advise everyone, there are no failures, super! View detail
It will last for 20,000 km with plenty of time to spare!
I always use it as a V Belt for my PCX which I usually use for commuting.
The last time I replaced it was at 50,000 km, and now it is over 70,000 km and has been used for over 20,000 km, so I have replaced the Weight roller, Slide Piece and Quantity:I replaced it with a set
The V Belt that was removed was very clean and did not look much like a new one. 。 The width was measured and found to be only about 0.1mm less than the description of the product. "The limit is 1mm or more less than the specified width dimension." It is unlikely that the amount will be reduced to the Spec. limit under normal use.
However, if you look closely at the reverse side of the Belt, you will see fine cracks, which is a unique feature of this Belt, Dual structure of standard rubber and high elasticity heat resistant compound rubber. However, the limit of the spec. is around 25,000 km.
The weight roller that was replaced at the same time after 20,000 km is not worn unevenly, but it seems to be a little smaller than the new one. 。 According to the actual measurement, all rollers seem to be 0.3mm in diameter and a little less than 1mm in circumference, and they may be 1 to 2g lighter. 。
Recently, fuel consumption has been below 45km per liter more often than not, and I thought it was because of the colder weather, but maybe it was because the weight roller was lighter and the emphasis was on acceleration. 。
Considering this, I would say that the weight roller, slide piece, and V-belt should be replaced at 20,000~25,000km, and the Torque Camshaft should be disassembled, cleaned, and greased up in quantities.:I think it would be better to do this with Set.
View detail
Recommendation.
I bought it again because it was the same one that was previously installed. The one before the replacement was worn out to the point that the Belt bump was gone, but it didn't break. great?? quality and very reliable product. View detail
I think it's the best
Quality control is well established.
No matter when you buy it, you can rest assured that it will work.
The price is acceptable.
View detail
great belt daytona
I ordered a belt, it arrived in 2 weeks, the belt is very high quality in the packaging, I haven’t installed it yet, I recommend buying it View detail