【PRO TAPER】SEVEN EIGHTH Handlebar Review
Normal Handlebar
Very decent Handlebar at an affordable price
There is quite a wide variety, so you will be able to find something that suits you.
Responses
Other reviews
Used for XLR80 Handlebar
[How is it used?
I purchased this product because the OEMHandlebar was bent
The height of the Handlebar is just right and it seems sturdier than the OEM.
Was the one you received as per Image?
It was just like the image.
Was the installation difficult?
The Switch floats a little because there are no holes for mounting the Switch, which was the case in the OEM version.
Other than that, there are no problems. If you are concerned about it, drilling holes will help it arrive nicely.
How was your experience with it?
The height of the Handlebar has been obtained, and it is now at a good height for both Sitting and Standing.
[Included Parts:were they on?
Sticker was included.
[Was there anything that disappointed you?
Not particularly.
View detail
Can be mounted on WR155
[How is it used?
Available for WR155 Handlebar.
OEM is low, so anything taller than this item may be tough.
Also, this Handlebar is too low, making it difficult to close the Bolt on the Clamp.
Was the one you received as per Image?
It was just like the image.
Was the installation difficult?
Drilling is required to replace the handlebar.
How was your experience with it?
It is a good aperture.
[Included Parts:were they on?
It came with a set of bar pad.
Bar end caps were included.
[Was there anything that disappointed you?
Not particularly
Other items that would be helpful
Installation points and hang/Availability and clarity of the Instruction Manual/Points to consider/Items to purchase/Opinions and requests to the Manufacturer
View detail
It's still cool.
[How is it used?
I bought a CRF125F and replaced the OEM handlebar with an Aluminum handlebar. The hand guard that I always use is only for Aluminum Handlebar.
I really wanted the 110 mini from Renthal, but the delivery date was undecided, so I had no choice but to go with this one.
Was the one you received as per Image?
The image is exactly as shown in the image. The quality is perfect.
Was the installation difficult?
Just replace it with OEM.
You can take a picture with your phone before you remove it so you can see where the Wiring and Wires went through.
How was your experience with it?
I knew from the measurement that I still lacked a little bit of start-up, but it wasn't so much that I couldn't ride, so I was satisfied.
I'm also thinking of chewing on UpClamp.
[Included Parts:were they on?
Bar pad is attached.
I am thankful that the CRF125F does not come with OEM.
[Was there anything that disappointed you?
Not particularly
Other items that would be helpful
Installation points and hang/Availability and clarity of the Instruction Manual/Points to consider/Items to purchase/Opinions and requests to the Manufacturer
Grip will need to be new and should be bought at the same time.
This time I decided to go with SCOTT's Mellow Grip. (https://www.webike.net/sd/24982240/)
Also, Grip bond, which is often forgotten. (https://www.webike.net/sd/20034236/)
View detail
Just low enough
Used for Z125PRO
HURRICANE Condor is not yet in stock, so I changed it to this one for the time being.
Position is good, although some holes need to be drilled to stop the rotation.
With Striker's Rear Sets, the look is neither too aggressive nor too rough.
View detail
Suitable for MOTARD
In use with dTRACKER.
The height aperture width is excellent.
View detail