【TANAX】Bracket Holder Review
Adjust Mirror position
Spacer is included to accommodate multiple handlebar diameters.
Because of the Spacer of the genus Gold, it may damage the Handlebar in some cases.
Convenient for adjusting the angle and position of Mirror.
Responses
Other reviews
CT125 CT110 HUNTER CUB Quantity:Pair (for Left and Right) Exactly to align Mirror back and forth
[How is it used?
The OEM LeftMirror Holder is located closer to the front (body side) than the Right Mirror Holder, which reduces visibility.
Quantity:Pair (for Left and Right) The LeftMirror Holder was introduced to shift the LeftMirror Holder forward because of the uncomfortable difference in the front/rear position in the
Was the one you received as per Image?
The surface has a luster feel, and I felt it had a higher quality feel than the OEM Mirror Holder.
How was your experience with it?
As per Image, Quantity:Pair (for Left and Right) The difference between the front and rear at the left and right mirrors is no longer a concern, and the LeftMirror is now in front of the
Rearward checks are now easier.
There was no change in Mirror vibration while driving.
View detail
Diversion to Mounting Bracket of Asahi Windshield
Used in place of the mounting bracket of the Asahi windshield, which is notoriously difficult to position.
Even when tightened, Quantity:Pair (for Left and Right) In this case, it is easy to create a Center by simply aligning the height and opening angle.
The bracket of the Asahi wind shield is a standard mounting bracket, and if you tighten it strongly, it is likely to crush the screw mount, so if there is any damage to the mount, it is better to use a new bracket.
View detail
I used it for MeterCustom in DAX.
When replacing the DAX Meter with a Takegawa
I used it as a mount base to the Handlebar.
Compact both horizontally and vertically, so you have a lot of flexibility.
It's easy to see and I was able to put the Meter in just the right place.
I think they are the same as the Navigation Holder Parts, but they are 22.mm and 25mm.
It can be used with both Handlebar, so it is useful for Custom use.
View detail
Repeat
I had the same one on, but I had to repurchase and reinstall it to change the angle.
However, the bolt is too thin and the torque-tightening torque is not enough, and when the weight exceeds 100kg, the Mirror turns around due to wind pressure.
It's a shame that it's so weak.
I drilled the hole to the Handlebar and screwed the Bolt in.
Last time I was cutting from the top and there is a hole in the handlebar, so this time I cut from the bottom.
If you do this, you won't be able to fine-tune it and you won't be able to get it back, so make sure it's in the Mirror adjustment range and drill the holes.
I... No one does. (+o+)
View detail
Repeat
I bought it again because I bought it before and it was good The installation is solid, so I bought a bracket for different purposes on top of this one and the Camera I put it on and load my phone on it The other Holders feel too delicate to use anymore View detail