【ACTIVE】Master Cylinder Switch Kit Review
Mechanical is nice, isn't it?
I wish I could attach it to RCB's radipon...
I bought it because I thought it was a good idea.
The hydraulics are not very good… and the standard ones are not very flattering… either.
Of course, it could not be attached as it was, but it was fortuitous that it could be done with a simple modification.
I just didn't expect to need additional parts. By the way, the shaft collar with 8mm inner diameter is Quantity:2pc. Set was required.
Responses
Other reviews
A necessity for driving on public roads.
Brake switch required when using Racing radialMASTER on public roads.
It requires dexterity and subtle adjustments to install small parts, and you must be able to devise a way to use the device when it does not work well due to individual differences.
Since it is a Mechanical Switch, if it is attached properly, the Brake will turn on without fail and there is no discomfort in lever operation.
View detail
I bought it for a radiphone from F. Landor, so it's not an option.
Purchased for the brembo copy of Fu Landor's Rajapon.
The thickness of the lower part of the pivot shaft is different between brembo and landor. I thought about heating the collar and inserting the collar, but it would be inconvenient to do that when changing the lever.
And BodyBody also has a different size than brembo?
Maybe I should have bought the M8 or M10 13mm washer, but I didn't have time, so I shaved off a little bit of the body with Grinder and installed it. It's very easy to use.
View detail
Hydraulic Brake Switch haters need it.
Installed on a pseudo-flavored Landor Radial master & omega;
There is almost only a Copy product, and this mechanical contact Brake Switch Kit of for Brembo also comes with, but because the kit itself is made by Third Party and it is a half forced flavor, some small processing is indispensable.
You could have done it as a homemade DIY project without using the kit itself, but ω
It is good to apply Screw Lock to the Base plate style aluminum plate located under the Lever after temporary assembly and tighten it moderately because Lever's movement will become reluctant if you tighten it too much!
The mechanical contact brake switch that comes with the kit is two steps lower in quality than the Honda OEM product, so it's better to put it together as a spare.
The Plate of Gold that is attached to the lower part of the DialAdjuster of the Lever is not usable with the Aluminum Collar that comes with the Kit because the diameter is too small.
I think it's much easier to use and has a wider range of adjustments than a miscellaneous homemade DIY product.
View detail
Brake switch
The installation itself is not so difficult, but it was a little troublesome because it would require adjustment. It looks good if Bolt of Lever pivot looks a little bit better using Bolt. View detail
I bought it for brembo Radio Pong.
I bought it because the Brake switch of brembo Rapon has broken.
Installation is not too difficult.
However, there was a Point where Switch does not work when adjusting Brake position.
It now works when you adjust using Tie Wrap.
It's a shame just because the price is cheap.
View detail