【M-Factory】Spring Hook Review

Exhaust Spring removal!

[How is it used?
When changing oil, the drain bolt cannot be removed without removing the exhaust pipe of the exhaust system.
Was the one you received as per Image?
Yes
How was your experience with it?
It was very convenient. It was so good that I felt like a fool for having worked so hard with Radio pliers.
It is only a few hundred yen, so it is worth having if you often remove Spring.
It is useful both when putting it on and taking it off.
[Points to note]
None
How did it compare to other products?
Anyway, it's cheap! View detail

Good enough for the price.

I chose this product because of the price, but I am fully satisfied.
The consolidated Spring of Exhaust System is sufficient for this purpose. View detail

Enough for Sunday mechanic

[How is it used?
STAND and Exhaust System during vehicle maintenance (Chamber) It is used to remove and install Spring for replacement etc.
Before purchasing this product, I had been working hard with a radipen, but I purchased this product to increase work efficiency.

Was the one you received as per Image?
It was just like the picture.

How was your experience with it?
The hook is processed so that the tip of the hook is tapered, allowing for smooth attachment and removal of the spring.
Also, the T-section is well reinforced, and although it is inexpensive, it does not seem to break easily.
The size is neither too small nor too large, but just right.

[Points to note]
None in particular. Surprisingly comes into play when it comes to maintenance.

How did it compare to other products?
This product has no problem, but some of the ones I used in the past had no reinforcement at the T-junction and would break off.
This is a part where force is inevitably applied, so I think this product is good because that part is reinforced.

【Review】
It is fairly inexpensive, but I think it works well for starters.
As expected, the durability will be inferior to those of famous manufacturers when used over a long period of time, but I think it will be sufficient for Sunday mechanicLevel. View detail

Convenient to have

[How is it used?
YAMAHA XJR400R (07) Exhaust System replacement, etc.
The Exhaust System is removed when the Exhaust System is replaced at the time of vehicle inspection or when the Oil Filter is replaced.
In doing so, I have been using Pliers and others to pull Spring, but it is quite difficult to do.
I knew there was an exclusive product, but I had not been able to purchase it.

Was the one you received as per Image?
The image was exactly as shown in the image.
I was reluctant to use it because it has only one application, but since it is compact, it is easy to place.

How was your experience with it?
It is quite easy to use.
Installation and removal of Spring is now much easier.
I wish I had bought it sooner. w

[Points to note]
Nothing special, but be careful not to work on Spring so that it doesn't blow up!

How did it compare to other products?
I don't know because I have not used other products, but considering the price, I feel this product is fine.
It has the best cost performance. View detail

It's so easy!

Purchased to remove Spring for replacement because the Screw threads on STAND's Nut were crushed and spinning.
I tried to replace it with a S-shaped Hook, but I was able to remove it, but I couldn't put it back on and the Spring flew off like a bullet.
It requires a certain amount of force, but I wish I had bought it in the first place if it was so easy to detach and reattach. View detail