【A-TECH】Heat-Insulating Material Review

New ModelGSX1300R HAYABUSAMagical racingSide cover was used.

As I mentioned in my recent impressions, I thought the Carbon Side Cover was too thin and would burn my inner thighs. So, I decided to use it.
I talked to Dealer and he recommended 2Quantity with room to spare.:Set purchased. Impressions.
If you want to put it on the wrong side of the wall, or if you want to put it on the wrong side of the wall, you can use the 3Quantity.:It may be safe to Set.
The ride no longer feels hot, so there is a definite effect.
I'm not complaining, but I was only concerned about the slightly longer delivery time (about a week for me). View detail

Good horizontal Size feeling.

I was looking for a replacement for the Heat Insulating Material inside the Side cowl of my TZr50R as it was peeling and falling apart.
The chamber and exhaust pipe are along the side of the side cowl, so it is good that it is horizontal.

The deciding factor in the purchase
I bought it because the horizontal size is just right and it was inexpensive.
Since this is an A-Tech product that deals with a lot of exterior parts, I thought that the selection of the Heat Insulating Material would also be correct, which was also a deciding factor.

[Impressions of using it]
The Heat Insulating Material comes with double-sided tape and can be marked on the backing so it can be cut out Exactly.
I don't know how well it shields the heat since I haven't checked it properly after installation, but it looks fine.

Products compared
We compared it to Striker and Posh Heat Insulating Material.
I chose this product because it was in stock, had a good Size feel and was inexpensive.

【Review】
I'm glad I bought it because so far the adhesion and thermal barrier performance seem to be fine.
Now I'm hoping it will last a long time. View detail

It has a rectangle of 5 cm x 100 cm, and since the flesh side of pasteboard is paper, it can use a Magic. since -- it is best to make and cut off a model. Thickness was stuck inside the Undercowl so that it might not melt about 1.5 mm with the heat of t

It has a rectangle of 5 cm x 100 cm, and since the flesh side of pasteboard is paper, it can use a Magic. since -- it is best to make and cut off a model. Thickness was stuck inside the Undercowl so that it might not melt about 1.5 mm with the heat of the

[attachment and the effect
] and a Muffler. The marks where the Cowl and the heat insulating material burned are nothing so that the heat-resistant effect may be enough. It stuck on the Carbon sheet of
.0.3mm, and stuck it on the Rear frame. When it sees targeting the exothermic fall from a Frame, heat is felt although it came to touch empty-handed. Since it was thick, the

[general comment]
and thickness have expected that the heat-resistant effect was 1.5 mm. Since it is merely a rectangle, it is troublesome to make a form. View detail