【DAYTONA】Front stand 3 Review
Maintenance Stand
I purchased this for use on my z900rs.
Bolt is removed due to interference between Arm and Brake hose.
Responses
Other reviews
Almost perfect except for the price.
The front and rear stands seem to be the best in a certain manufacturer, but this product is sufficient for cleaning and simple maintenance at the Amateur level.
However, the price could be lower, so the rating was not a perfect score.
View detail
Suitable for any type of car
Anyway, it's easy and convenient!
There are several different thicknesses of Head.
It is basically applicable to any type of car!
Cheaper than J something and perfect quality.
View detail
Cospar good
I have wanted a Front stand for a long time, but was hesitant because of the high price. I have been using it on my 2021 MT09 SP. There is a slight interference with the bracket of the Horn. Also, it is necessary to pull the harness closer when lifting it up. However, it can be used because it is at a level that can be counteracted. Be sure to raise the Front after raising the Rear. This is a satisfactory product with good usability. View detail
I was finally able to float the Front.
I had been wanting a Front stand for a long time, and after looking around, I found one at a reasonable price, so I snapped it up.
I also purchased a dedicated Adapter at the same time so I could Front up without any problems.
It is Steel, so the weight is reasonable, but I think it is also durable.
There is a concern that the paint may peel and rust where it comes in contact with the ground, but this is OK as long as it is used with care.
View detail
Second one.
I already have a 2 generation old DAYTONA CFCSTAND as you can see in the picture.
However, it cannot be used because there is no Adapter available for the ZX-25R.
I heard that there are some strong people who make their own Adapter and use it, but I bought this product because it is troublesome for me.
However, the Adapter that can be used with the ZX-25R is sold separately and must be purchased together.
In the case of ZX-25R, there may be individual differences, but the position of the Horn terminal is in the way of the Stem hole.
The Adapter will not fit....no problem if you loosen the Bolt that holds the Horn in place and flip the terminal position.
As for the quality, it is generally fine.
I already had the old product, but Quantity:2pc. Even if you buy the second set, it is less than the price of 1 pc. of JTrip, so it will not be disturbed by Garage.
If not, then Quantity:2pc. I think it's fine to have a Set. However, the older model could not be used on the 2010 MODELF model ZX-10R. Inner cowl cracked when I tried to lift it. So I am a little doubtful about the universality of the latest Front stand3. If you are not sure, I recommend you to use JTrip from the beginning.
View detail