【brembo】Radial 108mm Monoblock Caliper Kit M4 (Left and Right Set) Review
Fits: HONDA CB1000 R, HONDA CB1000 R, HONDA CBR 1000 RR, HONDA CBR 1000 RR, HONDA CBR 1000 RR, HONDA CBR 1000 RR, HONDA CBR 1000 RR, HONDA CBR 1000 RR, HONDA CBR 1000 RR, HONDA CBR 1000 RR SP, HONDA CBR 1000 RR SP1, HONDA CBR 1000 RR SP2, HONDA CBR 600 RR, HONDA CBR 600 RR, KAWASAKI Z 1000, KAWASAKI Z 1000, KAWASAKI Z 1000, KAWASAKI Z 1000 SX, KAWASAKI Z 750 R, KAWASAKI Z 750 R,
Impulse purchase.
What made you decide to buy?
Recently, OEMs are installing more and more brembo. My ZX-6R has also been fitted with brembo since delivery. Someday I'll have a Brembo caliper!" I had envisioned this. Then, my first tinker of 2023 was to strengthen the Brake! Originally, I was going to finish with Master Cylinder and Brake line, but when I happened to wander around Webig, I found …Brembo caliper at a low price for some reason, and it was almost an impulse buy. After that I was more and more motivated to work! (Lol)
[How was the installation?
We replaced the Master Cylinder and Brake line at the same time, so it took us about 2 days to finish all the work.
The ZX-6ROEMFront Disc is 310mm long. So, we prepared the following PLOTbrembo Offset collar When PLOTbrembo Stainless SteelCaliper Mount Bolt Caliper is easy to install, just be careful not to drop it. The only thing you have to do is to be careful not to drop it. Others, be careful to fix the banjo bolt in place, avoiding the brake banjo so that the Caliper Mount Bolt can be removed. The torque specified for the Caliper Mount Bolt is 35 N.m. The Torque specified for the Caliper Mount Bolt is 35N.m. There is no Instruction Manual for installation. (Lol)
The Right SideCaliper is farther away from the MASTER, and air bleeding is done at the Right Side→Left Side→MASTER. After the air bleed is completed, brake fluid may seep out from the Breeder Valve of the Caliper. In that case, you can clean the inside of the BreederValve with Brakes cleaner, twist the Dustcloth, and suck the Brakes cleaner inside the Breeder. Do not tighten the Torque too hard because of seepage. If you tighten it too hard, the Breeder Valve will be damaged. Be careful not to turn on the power before and during air removal. If you turn on the power by mistake, it will cause a malfunction of ABS and you will be sent to the manufacturer.
Please note that there is a law that states that only the owner of the motorcycle or a licensed mechanic can perform maintenance and parts replacement related to the brake. I am a former Owner." Please use this as a reference only, as we have performed maintenance on the
How was your experience with it?
I replaced the MASTER and brake line at the same time, so I feel like it is grabbing the disc firmly. I don't know how small the change is because it is not a PRO Racer, but …Anyway, I think it will take some time to get used to it because of the difference from the OEM Nisshin BreakingPoint.