【SYGN HOUSE】Vibration Guard Exclusive for MOUNT SYSTEM Smartphone Holder Review
It's not working
I bought it because I was worried about the phone malfunctioning, but it is obviously too soft and I think it shakes a lot while driving.
In my case, I did not install it because it is located close to the tank and it might shake and hit the tank.
It was too expensive to purchase as it was not usable.
Responses
Other reviews
Vibration Isolation Outclassing
A little soft, but firm and very good.
We will make it a good companion for future Touring.
View detail
SIGN HOUSE
I don't know as it has only been installed for a short time. View detail
More &hellip. than I imagined;
I was hoping that it would be an anti-vibration solution from the 1200ccLTWINEngine, and it must be effective because it was sold out for a while at Motorcycle supply stores. When I actually used it, I felt that the rubber hardness was too soft. I think it would be better to reduce the amount of deformation of the rubber a little more. View detail
Design and quality are good but squishy
I think Vibration is effective, but it is too Kunikunashi and very cumbersome to install and remove the phone. View detail
I bought it to try it out.
I bought it to see what it was like.
I think it had what I needed, I don't remember if Screw lock was included.
Installation is easy and can be done quickly by referring to the Instruction Manual.
I think I have driven about 4000 km using it. At first, I was uncomfortable with the higher position of the phone, it is higher for the thickness of the Rubber part.
The softness makes it difficult to adjust the positioning of the phone. It is also difficult to detach and attach the cell phone. Well, it is a matter of getting used to it.
While driving, you can see that the vibration is mitigated. That said, the screen is not difficult to see.
It is difficult to operate the screen while the Holder is attached. Once you get used to it, it is no problem.
I think the protection of the mobile Camera is working.
It would have been nice if the rubber was a little stiffer. Also, it would have been nice if it could be kept within the length of the Parts before installation.
View detail