【CLEVER LIGHT】ZiiX Lap Timer Review
In Lap timer, the Popular
After all, it is difficult to find the Sensor's mounting position.
Use is fine.
Currently, I am using Button batteries, but when inserting the batteries, the lid is incredibly hard, and I was afraid that it would break if I put any more pressure on the claw.
Also, when I bent the BodyBracket, the paint peeled off ParaPara as shown in the photo (lol).
Responses
Other reviews
Circuit Running
I want to measure lap time in Circuit.
Purchased
I still need to know where to install the Sensor part and Wiring.
It was Large strange to pull it in.
We will verify if Time can actually be picked up properly.
View detail
Circuit Running
I bought this for a Circuit run.
As others have written, the Sensor portion of the
I am at a loss to install it.
Installation location, installation bracket, etc. are time-consuming.
It will take
You must be able to tinker with Motorcycle in a certain way.
Installation may be tough.
View detail
No problem, it worked!
It worked fine at Twin link Motegi! View detail
Used in Scooter race
Installed on a 4-stroke JOG.
After confirming that the Sensor responds to the magnet, it is brought into the Course, 10 cm above the mounting ground, and there is no response in Tokushima CartLand.
Next time I will ask CourseOwner if there is a magnetic bar and then try to adjust the Sensor position etc.
View detail
magnetism
By Circuit
The magnetic strength that can be picked up seems to vary
If there are times when you don't pick it up at all and don't even Start.
Start, but by the time you've done three rounds, you've done three rounds.
You can also try to display a wrap.
Circuit is able to measure and display every lap without any problem.
The fact that it is there means that as long as it can pick up magnetism, it should be fine.
I think it depends on the Setting of the user.
View detail