- Home
- Product reviews
- Motorcycle Parts
- Bodyworks
- Fenders
- Fender Eliminators
- It's just too expensive.... (ADIO: Fender Eliminator Kit)
【ADIO】Fender Eliminator Kit Review
It's just too expensive.
It's just a Fender Eliminator, but it's too hard to put on.
มันแพงเกินไป
เป็นแค่ Fender Eliminator แต่ใส่ยากเกิน
Show originResponses
Other reviews
I do not recommend it.
[How is it used?
I installed this on my commuter vehicle, a CYGNUS X 5 model. I was wondering if I would do the Fender Eliminator since I use it for commuting even on rainy days.
I got tired of the wild OEMFender that I saw every time I looked behind me and decided to install it.
Was the one you received as per Image?
The number of parts is smaller than I expected, and I thought it was such a Compact.
The material is probably steel, and the paint is weak and will soon peel off if bumped during installation, so be careful. Be careful when you bump it during installation.
Was the installation difficult?
It is not difficult, but it is a bit tedious because the entire rear cowl must be removed.
However, there are only a few Bolts that are stopped, so having the interior stripped makes the work much faster.
I use Emon's inner lining peelers.
The Instruction Manual is attached, but it is gubby and not clear. I think you will understand it if you look at the thing and the actual car and think about it.
I had to check the contents of the Instruction Manual for the center plate on the Net to install it because it made no sense to me.
How was your experience with it?
Honestly, it sucks except for the Styling from the back and the ability to install without cutting the OEM.
I would not recommend it to others, I feel.
First of all, the accuracy of the product is poor. I fine-tuned it many times until I was satisfied.
Plate bending accuracy may be poor, or there may be a gap between the boti or when tightening the number.
Bracket has floated away and the only way to tighten it up is to force it.
I had no choice but to hand Bent and install it myself to some extent.
[Included Parts:were they on?
The pictures are as shown. The basic bolts are OEM.
[Was there anything that disappointed you?
As described in the photo at the end of the image, the back of the Number is immediately Battery case.
Wiring is also fully visible. 10,000$ Fender Eliminator. I wish they would make it more seriously.
OEM Fender is $3,000 for a new one. It's not that expensive.
We recommend WirusWin's OEMCut type Fender Eliminator.
Wiring is also not really possible for the governor to be in full view, so I will make my own mudguards out of plastic dampproofing.
As I said at the end, I cannot recommend this Fender Eliminator.
View detail