【DRC】Stainless Steel Brake Pin Set Review
Fits: YAMAHA YZ450FX, YAMAHA YZ450F, YAMAHA YZ426F, YAMAHA YZ400F, YAMAHA YZ250X, YAMAHA YZ250FX, YAMAHA YZ250F, YAMAHA YZ250, YAMAHA YZ125X, YAMAHA YZ125, YAMAHA WR450F, YAMAHA WR250F, SUZUKI RM-Z450, SUZUKI RM-Z250, SUZUKI RM250, SUZUKI RM125, SUZUKI DR-Z400S, KAWASAKI KX250, KAWASAKI KX125, KAWASAKI KLX250,
klx250Brake pin replacement
I had no problems, but since it is an old car, I replaced the brake pin to prevent it from sticking due to rust, and since it is integrated with the cap of the blind, I don't have to worry about losing it.
Responses
Other reviews
Improved serviceability
OEMs can replace the 2-parts configuration of the Hexagon Bolt Pin+Minus screw blind with a single 8mm bolt.
The 8mm bolt is also used frequently for maintenance around the brake area, so the assortment of tools can reduce the man-hours required for the work.
In addition, the OEMs were concerned that the outer screw would burn even if Thread compound was used, and the use of a slotted screwdriver would cause the screw to lick every time it was removed, but due to the characteristics of the screw, the possibility of this happening is relatively low. 。
(We still recommend the use of CopperGrease on threads, as seizure itself will occur.)
Replacing one Brake pin will not make you run faster or ride easier, but it will reduce the burden of maintenance.
View detail
Pin is too long for early BAJA and hits Spoke.
I thought it was a cheap Front and Rear Set and installed it on my early BAJA, trusting the fitment guarantee, but it was too long in both directions compared to the front and rear pins, and it hit the Spoke too hard to use. It was a very expensive purchase. I will never buy again. View detail
better than factory
The brake pin looked like oem quality and fit inside the caliper perfectly. DRC products are really good, a little bit expensive. I prefer hex head instead of allen. Especially when allen tend to take over a bit after a while.Had to drill my oem ones out because they seized in my calipers and the Allen heads stripped out. Got these to replace them. The fitment was great and installation was easy. I've run them for about six rides so far and haven't seen any problems.Overall perfect fit. It looks very solid and high quality. Shipping is very fast, very well packaged. arrived in 1 week View detail
The OEM was corroded.
I bought it because it seems to be resistant to corrosion.
The original was corroded and was replaced while BrakeOverhaul.
View detail
Higher quality than OEM
I bought it because the OEM came out with Stages.
It looks polished and has a high quality feel, and it is stainless steel, so I expect it to be rustproof and durable.
The smooth surface may also improve Pad movement.
View detail