【OPMID】Protective Film For OP Multimeter Review

Lay the square section down first then the round section...

Because the protective film is cut almost exactly the same size as the face of the Opmid multimeter, the film edges will not lay flat if it's not set down perfectly. Opmid should have pre-installed these films on the multimeter at the factory, hence 4 stars. Onces you get it perfectly centered, the film is excellent. The matte, non reflective film I chose works great in sunny condtions. Great that you get 2 films in the pack, backup or just in case... I'd recommend it, a good way to keep the face from scratching and less glare from the sun. Just take your time installing and use painters tape to remove dust from the 2 surfaces before you lay it down and push bubbles out. View detail