【KITACO】Pulley Holder Review

Required for Flywheel removal

Used to loosen the center bolt when removing the flywheel.
Functionality is fine.
The restrains on the Adjustment Bolt were reluctant to move and could not be fixed properly without support. View detail

Versatile Holding Tool for your Maintenance Needs

About quality and texture: I am happy with the quality of the pulley holder from Kitaco made from a steel construction with a PVC coating over the band to help improve it's hold.About the feeling of use: I have used this tool to hold the clutch and flywheel on my Honda Grom when removal of these parts were required for maintenance with great success. The adjustable band makes this tool very versatile for varies sized motorcycle parts.Products to buy together: Some more tooling like a center lock nut wrench would also be desirable to purchase along side the pulley holder so when it comes time to remove the clutch assembly and oil spinner on your Honda Grom you have all the special tooling required to complete the job.Difficulty of installation: The process to install takes a few minutes, place the pulley holder around the part that needs to be held and adjust the band if required. Tighten down the T handle so that the band holder does not allow the part to spin as you undo the fastener securing the part. Not difficult to do.Cost performance and comparison with other products: Good costing as this is a quality made band holder from Kitaco that has with stood numerous usage without failure as compared to the first band hold that I purchased from another site that failed soon after.About shipping and packaging: The faster shipping options are too expensive for myself so I just have to wait for my part to arrive via sea freight. Webike kept me updated on the status of my order up to when it shipped. The parcel arrived within the expected date range and was well packaged with no chance of the part being damaged.Any concerns, cautions, or advice when purchasing: These band holder are limited to the sized parts they can hold. No smaller the 6cm in diameter and no larger then 12cm in diameter. View detail

Restraint device

In overhauling Clutch of SUPER CUB, a tool to fix Clutch became necessary. There were several kinds of tools to fix, but I chose Pulley holder which is tenacious for the time being

Clamp the Holder in Clutch, rotate the handle and tighten it to complete the set. I was able to remove it easily by putting pressure on Lock nut using exclusive Wrench. Clutch that was immersed in oil can also be fixed without slipping

I found out when using it, but Clutch still moves with just being caught in Pulley holder. So when detaching you must hold down the handle or hook it somewhere so as not to move. Naturally? - ω - `) View detail

It was able to be used without problems

Purchase for Clutch exchange.
Quality was also good and could be used without problems

The price is reasonable as it is

Because it can only rotate by 180 ° in the attached Lever
I felt uncomfortable with a small car like 4 MINI.
If the tip is hexagon etc. so that it can be used even with Spanner etc.
I thought it was more convenient to use. View detail

This can be used.

I used it for desorption of Pulley of CYGNUS1YP.
Shaft is attached to the Handlebar part so that it can be tightly tightened, but if you tighten it with so much power, you can hold it firmly.
Initially, I wondered whether to become Universal wrench, but because the hooked part is deep, it is hard to use (Not available) Because there was information that it was made to Pulley holder. Results were purchased and correct answer was Large.
There is no place to use it, but the Red Rubber to hold it is weaker than we thought, it will be soooolid but it seemed like it was good to have bought it after a long time. View detail