【MotoCrazy】Meter Protection Film (for Vehicle) Review

Same as Film on your phone.

It's a Film just like the Film on your phone.
But it's not GlassFilm, so it's what we call a PelePera.
It is possible to install it easily if you pay attention only to the pasting position a little.
I'm almost certain that the Meter won't get damaged, but I put it on just in case. View detail

The corners turn up

I use it with 125DUKE
On days when the wind is low and Dust is hard to dance around, wipe it clean with a Parts cleaner and let it dry before I put it on, and while it was good right after I put it on, I'm doing a test run on another Custom The corners came off after a few hours or so It's just the corners, so I'm leaving it on, but it could be a little more adhesive
It is a protective film, so it is good as long as it is covered

Like when I failed to paste a phone Film, only around the edges, making it difficult for Meter to be visible It's not peeling off to the part, so I'm going to test how long it will last View detail

To protect the LCD screen!

I installed it to protect the screen of my LCD Meter!
It took a little bit of work to make sure that Dust doesn't get into it when you put it up, but it's a good idea to put it up without Dust in one shot I was able to!
The clarity is good and the way Meter looks is fine View detail

You can't even see that it's attached

I bought this to prevent scratches and it is so beautiful that I can apply it without air bubbles and you can't even see it
There is no problem with this type of product, although it has the drawback of getting air bubbles when it is applied
The other thing is that it's degrading over time View detail

it is better to have it than not

It was originally a used car body with Wound on it, but I bought it so that it wouldn't stick any more!
Adhesion was able to be done easily with adsorption, but the edge where Clearance is large is a little empty I think it's necessary before Wound causes diffuse reflections and makes it hard to see View detail