【HURRICANE】Windshield Protector Review

No effect in Normal position

This Motorcycle OEMHandlebar Quantities to Upright:The upper body is set so that the upper body is in an upright Riding Position.
At this Visor height, the feeling of receiving wind is almost the same.

It would be effective to replace it with a Swallow or Condor Handle, though.
However, according to the manufacturer's website, it does not seem to be possible to attach the separate handle at the same time.

Even as a Meter visor, it is ineffective because the Meter is located far from the Headlight.
It seems that there are several Meter Brackets available from several companies that can be moved forward, so if you are doing such a Custom
I think it will be effective.

It doesn't sound like it says much good, but I like it because it looks better. View detail

Parenthesis OK

Purchased for the XSR700
I chose this one because of the better cosmetic value compared to the Yamaha OEM
It's easy to install and takes less than 20 minutes to complete while reading the instruction manual
The rectification effect is subtle, but I personally think it looks better than the OEM Product
Material:It is said that ETC radio waves are not allowed to pass through due to the material of aluminum, so the installation position of Antennas It is important to note that the View detail

It's not too flashy and it's not too tasty..

I was looking for Front visor and it was a pouch as a candidate,
Purchase purchased for a moment because punch is missing item.
However, when I installed it, it became a favorite without too much flashy.
Easy to install and Fitting is also good.
Is the rectification effect better than Visor itself is not Large, is not it?.
One dissatisfied point is that although a Rubber attached to the rim is bundled,
Did you want this to be glued from the beginning?
I had to stop at Bond and it will not be attached, and it was quite a pain to put on at Bond. View detail