【Osaka Fiber】Heat Resistant Cover Pad Review

Repeat Purchase

[How is it used?
I bought a new motorcycle cover, so I bought this product to prevent the exhaust system from melting due to heat.
The motorcycle is XJR1300C with Nojima's Full Exhaust System and the catalytic converter in the tail pipe section.
This Pad is essential as the temperature is quite high.

Was the one you received as per Image?
I bought it once, so it is as Image. The backing paper is a grid paper.
I think it's good that it's easy to cut and scrape when you see how large it is.

How was your experience with it?
The Motorcycle Cover will not melt if you just apply the Heat Seat, but it will melt if you stick it too tightly.
As expected, phenomena such as Seat scorching→Motorcycle Cover warping due to heat will occur.

[Points to note]
Be sure to degrease the Motorcycle Cover side before applying. Lack of degreasing will cause damage later on.
This is a good idea. If you do not have the time to do so, you may find that you have a problem.
In addition, before applying the cover, please check which part of the motorcycle cover you want to apply by using a step ball.
I think it's better to use Masking tape for marking and pasting to avoid mistakes.

By the way, if it gets wet on a rainy day and you don't dry it, it will grow something like mold (laughs).
To be honest, I don't care if Mold grows, it will probably be killed by heat.
If you care, don't forget to keep it dry! If you are concerned, don't forget to dry it!

How did it compare to other products?
I use it because there is no other similar product, but the Heat Seat for Under Cowl is more expensive.
It seems to be superior to the main product. If you are so hot that the main product doesn't work, you may want to try it. View detail

You can see where you pasted from the table of Bike Cover

I used it for Cover of Z1000.

Pasting was easy because it peeled off the back paper and stuck it on the back side of Bike Cover, but it was surprisingly Large strange to stretch out so as not to wrinkle, and it remained somewhat.

However, since I know where I pasted it from the surface of Bike Cover, I think that it is good to check if you are hitting a hot place firmly when you cover.

Since the Engine part of Z1000 has a Guard for preventing falling, it does not hit Bike Cover directly, so it is unnecessary, Quantity : Pair (for Left and Right) I wanted to stick it only to the Silencer division, but when checking before pasting, it was not enough to cover the whole Silencer.

Since we parked at Side Stand this time, I tried using it for Large for Right Side. (2. 5 to 1. 5)

Since the pasted part is reinforced more than Bike Cover alone, since the entire Silencer does not hit Bike Cover, there is no need to cover the whole, and Quantity : Pair (for Left and Right) Only one piece is enough.
(Where you are somewhat concerned, Jeans' cuts are pasted with Double-sided Tape)

I was able to do Bike Cover immediately after getting on and it became easy.
I think that I was glad I bought it. View detail

Construction is easy, Cost performance is the best

The commuter's ST250E Cover was blown by the wind and brought into contact with the Exhaust System, melted by heat and a hole opened, so I bought it for repair. It is a Seal format, it is easy to apply as a batch from the back, it is easy, and it will not burn. It is overwhelmingly cheaper than replacing with a heat resistant Cover and I think that it is recommended..
View detail