【WM】Handlebar Stopper Review

High quality

Purchased for reverse mounting a swCondor Handle on a w650.
I was prepared for this, but it reduces the angle of sharpness immensely.
UTurn is harder to do and considerably less maneuverable.
It was only de Tune, so I removed it as fast as I could and gave up on the reverse attachment.
But the product was polished and very beautiful. You can't see it once it's installed, but w
It was a good experience. View detail

Texture is good!

SR400 (1JR) I installed it on a Magura Separate handleSpec. car in the

I kept it off the vehicle for a while, but during this time I heard that Handlebar Lock is now being checked at vehicle inspections in my area, so I installed it along with the company's Handlebar Lock for the purpose of vehicle inspection and to prevent theft when the vehicle is stopped.

We felt that the quality was on the high side, even though it was inexpensive for an Other Brand Product Handlebar Stopper.

For installation, the company's Handlebar Lock and Quantity:It took about an hour to install with Set. View detail

It attaches, and it is easy and structure is also solid.

It attaches, and it is easy and structure is also solid. View detail

Quality WM Wellington

Convenient to install with Bolt On to the three-prong.
No complaints about the quality. It is also good that the Left Side Handlebar Lock can be used with the company's (WM) Top Bridge.

However, since the Optical Axis Adjustment Bracket is also co-tightened at the same location, the optical axis should be readjusted.
Also, if you are using a Blinker Bracketetc. to be installed at the same location, it may be better to use a Handlebar Stopper to be installed on the Frame side for better fit. View detail

The quality is good. But.

It is a very good product.
I think it is a very good product in terms of structure, finish, and texture.
However, I think the mirror finish on the exterior is excessive considering the area of use.
I'd rather have something like a Matte finish to make it less noticeable.

My personal hope is that
I wanted the Handlebar Lock to stop at the limit of its usable position.
We did some DIY work to shave the lock contact area and adjust the contact position so that we could use the Handlebar Lock.
However, with this adjustment, we were able to use the Handlebar Lock on our Handlebar to prevent the Handlebar from hitting the Tank, but the situation may vary depending on the Handlebar used, so it does not mean that this product is bad. View detail