【DRC】MOTOLED Flasher Register Review

To change LEDFlasher

As Rear's Blinker changed from a light bulb to an LED, as a measure against High flasher.

Just to interrupt Wiring.
No problem in performance.

I wish it could be a little cheaper ?? View detail

Since it was a Blinker of DRC in changing the pure Rear blinker of xr250, Register purchase was carried out for the prevention from malfunction. The relay was shelved by a rear deer and that which is changed and twisted. Thing [ ] arrives, and a

Since it was a Blinker of DRC in changing the pure Rear blinker of xr250, Register purchase was carried out for the prevention from malfunction. The relay was shelved by a

rear deer and that which is changed and twisted. Thing [ ] arrives, and although opened, consider and depend and XR250 has a Battery, a relay, a Fuse, etc. in the Number Shroud portion of the left rear greatly -- an excessive Space -- there is nothing -- it was equal and fixed between the Rear fender, the external Stop-lamp, and the black Fender integrated with a Number-plate pedestal. It is, if the Cable tie and Fender made of resin worry about whether it melts since it is hot and it becomes impossible to have by hand during

turning on electricity. If it is a Blinker of the electric lamp, it will not be needed in a Register - They are two stars from the reason more than . View detail

One was set to the single-sided Blinker for the time being, and since High flash carried out although the signal was taken out, although two were connected and the signal was taken out, the High flash has been carried out. if I will set only the

One was set to the single-sided Blinker for the time being, and since
High flash carried out although the signal was taken out, although two were connected and the signal was taken out, the High flash
has been carried out. if I will set only the Blinker of
back to LED, a Flasher and how purchased
constructs itself are not known [ whether it is bad and ] -- it is regrettable. View detail

[Webike Monitor] It purchased for the High-flasher prevention at the time of LED-izing the Blinker. attachment is very easy and only interrupts wiring of a Blinker. , however power dissipation are the same as LED-izing before.

[Webike Monitor] It purchased for the High-flasher prevention at the time of LED-izing the
Blinker.
attachment is very easy and only interrupts wiring of a Blinker.

, however power dissipation are the same as LED-izing before.

Since generation of heat is larger than imagination again, when turning on a Blinker for a long time in many cases, I consider that it is better to be cautious of
attachment place. View detail

CBR250R (managing contractor41) was attached to LED-izing. Since a high flasher is started in case of one register, we recommend you two-set purchase.

CBR250R (managing contractor41) was attached to LED-izing.
Since a high flasher is started in case of one register, we recommend you two-set purchase. View detail